TS68040 ATMEL Corporation, TS68040 Datasheet - Page 15

• Manufacturer Part Number: TS68040
• Description: 32-bit Mpu, 25-33 MHZ
• Manufacturer: ATMEL Corporation

3.5 - Mechanical and environment
The microcircuits shall meet all mechanical environmental requirements of either MIL-STD-883 for class B devices or for
TCS standard screening.
3.6 - Marking
The document where are defined the marking are identified in the related reference documents. Each microcircuit are legible
and permanently marked with the following information as minimum :
– Thomson logo,
– Manufacturer’s part number,
– Class B identification,
– Date-code of inspection lot,
– ESD identifier if available,
– Country of manufacturing.
4 - QUALITY CONFORMANCE INSPECTION
4.1 - DESC / MIL-STD-883
Is in accordance with MIL-M-38535 and method 5005 of MIL-STD-883. Group A and B inspections are performed on each
production lot. Group C and D inspection are performed on a periodical basis.
5 - ELECTRICAL CHARACTERISTICS
5.1 - General requirements
All static and dynamic electrical characteristics specified for inspection purposes and the relevant measurement conditions
are given below :
– Table 12 : Static electrical characteristics for the electrical variants,
– Table 13 : Dynamic electrical characteristics for TS 68040 (25 MHz, 33 MHz).
For static characteristics (Table 12), test methods refer to IEC 748-2 method number, where existing.
For dynamic characteristics (Table 13), test methods refer to clause 5.2 of this specification.
Indication of «min.» or «max.» in the column «test temperature» means minimum or maximum operating temperature as
defined in sub-clause 3.3.2. here above.
5.2 - Static characteristics
Table 12 - Electrical characteristics
– 55°C T C
Symbol
V OH
I TSI
V IH
V IL
V U
I IH
I in
I IL
T
Jmax
Input high voltage
Input low voltage
Undershoot
Input leakage current
Hi-Z (off-state) leakage current
Signal low input current
Signal high input current
Output high voltage
@ 0.5 / 2.4 V
@ 0.5 / 2.4 V
V IL = 0.8 V
V IH = 2.0 V
Larger buffers - I
Small buffers - I
; 4.75 V
V CC
OH
OH
5 mA
5.25
35
mA
V
Characteristic
unless otherwise specified - Notes 1, 2, 3 and 4
TIP, TLNn, TMn, TS, TTn, UPAn
IPLn, MDIS, PCLK, RSTI, SCn,
LOCKE, R W, SIZn, TA , TDO,
AVEC, BCLK, BG, CDIS,
TBI, TCI, TCK, TEA
An, BB, CIOUT, Dn
TMS, TDI, TRST
TMS, TDI, TRST
LOCK,
– 0.94
– 1.1
GND
– 20
Min.
– 20
2.4
2
– 0.18
– 0.16
– 0.8
Max.
VCC
0.8
20
20
Unit
mA
mA
15/38
V
V
V
V
A
A