WM8711BL Wolfson Microelectronics, WM8711BL Datasheet - Page 31

no-image

WM8711BL

Manufacturer Part Number
WM8711BL
Description
Ultra-Small Audio DAC
Manufacturer
Wolfson Microelectronics
Datasheet
Production Data
w
3-WIRE (SPI COMPATIBLE) SERIAL CONTROL MODE
The WM8711BL can be controlled using a 3-wire serial interface. SDIN is used for the program data,
SCLK is used to clock in the program data and CSB is used to latch in the program data. The 3-wire
interface protocol is shown in Figure 20.
Figure 20 3-Wire Serial Interface
Notes:
1.
2.
3.
2-WIRE SERIAL CONTROL MODE
The WM8711BL supports a 2-wire MPU serial interface. The device operates as a slave device only.
The WM8711BL has one of two slave addresses that are selected by setting the state of the CSB pin.
Figure 21 2-Wire Serial Interface
Notes:
1.
2.
Table 18 2-Wire MPU Interface Address Selection
To control the WM8711BL on the 2-wire bus the master control device must initiate a data transfer by
establishing a start condition, defined by a high to low transition on SDIN while SCLK remains high.
This indicates that an address and data transfer will follow. All peripherals on the 2-wire bus respond
to the start condition and shift in the next eight bits (7-bit address + R/W bit). The transfer is MSB first.
The 7-bit address consists of a 6-bit base address + a single programmable bit to select one of two
available addresses for this device (see Table 18). If the correct address is received and the R/W bit
is ‘0’, indicating a write, then the WM8711BL will respond by pulling SDIN low on the next clock pulse
(ACK). The WM8711BL is a write only device and will only respond to the R/W bit indicating a write. If
the address is not recognised the device will return to the idle condition and wait for a new start
condition and valid address.
SDIN
SCLK
B[15:9] are Control Address Bits
B[8:0] are Control Data Bits
CSB is edge sensitive not level sensitive. The data is latched on the rising edge of CSB.
B[15:9] are Control Address Bits
B[8:0] are Control Data Bits
SCLK
SDIN
CSB
START
CSB STATE
0
1
B15
R ADDR
B14
B13
B12
R/W
B11
ACK
B10
ADDRESS
0011010
0011011
B9
DATA B15-8
B8
B7
B6
ACK
B5
B4
DATA B7-0
B3
PD, Rev 4.1, April 2007
B2
B1
WM8711BL
ACK
B0
STOP
31

Related parts for WM8711BL