LPC2292 Philips Semiconductors (Acquired by NXP), LPC2292 Datasheet - Page 23

• Manufacturer Part Number: LPC2292
• Description: 16/32-bit Arm Microcontrollers; 256 KB Isp/iap Flash With CAN, 10-bit ADC And External Memory Interfacebased on a 16/32 Bit ARM7TDMI-STM Cpu With Real-time Emulation And Embedded Trace Support, Together With 256 Kilobytes (kB) of Embedded High Speed
• Manufacturer: Philips Semiconductors (Acquired by NXP)

Philips Semiconductors
9397 750 12748
Preliminary data
6.19.1 Features
6.19 Real time clock
6.20 Pulse width modulator
The Real Time Clock (RTC) is designed to provide a set of counters to measure time
when normal or idle operating mode is selected. The RTC has been designed to use
little power, making it suitable for battery powered systems where the CPU is not
running continuously (Idle mode).
The PWM is based on the standard Timer block and inherits all of its features, although
only the PWM function is pinned out on the LPC2292/LPC2294. The Timer is designed
to count cycles of the peripheral clock (PCLK) and optionally generate interrupts or
perform other actions when specified timer values occur, based on seven match
registers. The PWM function is also based on match register events.
The ability to separately control rising and falling edge locations allows the PWM to
be used for more applications. For instance, multi-phase motor control typically
requires three non-overlapping PWM outputs with individual control of all three pulse
widths and positions.
Two match registers can be used to provide a single edge controlled PWM output.
One match register (MR0) controls the PWM cycle rate, by resetting the count upon
match. The other match register controls the PWM edge position. Additional single
edge controlled PWM outputs require only one match register each, since the
repetition rate is the same for all PWM outputs. Multiple single edge controlled PWM
outputs will all have a rising edge at the beginning of each PWM cycle, when an MR0
match occurs.
•
•
•
•
•
•
•
•
•
Enabled by software but requires a hardware reset or a Watchdog reset/interrupt to
be disabled.
Incorrect/Incomplete feed sequence causes reset/interrupt if enabled.
Flag to indicate Watchdog reset.
Programmable 32-bit timer with internal pre-scaler.
Selectable time period from (t
t
Measures the passage of time to maintain a calendar and clock.
Ultra Low Power design to support battery powered systems.
Provides Seconds, Minutes, Hours, Day of Month, Month, Year, Day of Week, and
Day of Year.
Programmable Reference Clock Divider allows adjustment of the RTC to match
various crystal frequencies.
pclk
4.
Rev. 01 — 05 February 2004
16/32-bit ARM microcontrollers with external memory interface
pclk
256
4) to (t
LPC2292/LPC2294
pclk
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
2
32
4) in multiples of
23 of 40