DSPIC33FJ64MC508 Microchip Technology Inc., DSPIC33FJ64MC508 Datasheet - Page 75

• Manufacturer Part Number: DSPIC33FJ64MC508
• Description: High-performance, 16-bit Digital Signal Controllers
• Manufacturer: Microchip Technology Inc.

5.0
The Reset module combines all Reset sources and
controls the device Master Reset Signal, SYSRST. The
following is a list of device Reset sources:
• POR: Power-on Reset
• BOR: Brown-out Reset
• MCLR: Master Clear Pin Reset
• SWR: RESET Instruction
• WDT: Watchdog Timer Reset
• TRAPR: Trap Conflict Reset
• IOPUWR: Illegal Opcode and Uninitialized W
A simplified block diagram of the Reset module is
shown in Figure 5-1.
Any active source of Reset will make the SYSRST
signal active. Many registers associated with the CPU
and peripherals are forced to a known Reset state.
Most registers are unaffected by a Reset; their status is
unknown on POR and unchanged by all other Resets.
FIGURE 5-1:
© 2007 Microchip Technology Inc.
Note:
Register Reset
RESETS
This data sheet summarizes the features
of
of dsPIC33FJXXXMCX06/X08/X10 Motor
Control Family devices. It is not intended
to be a comprehensive reference source.
To complement the information in this data
sheet, refer to the “dsPIC33F Family
Reference
Microchip web site (www.microchip.com)
for the latest dsPIC33F family reference
manual chapters.
MCLR
V
DD
dsPIC33FJXXXMCX06/X08/X10 MOTOR CONTROL FAMILY
Uninitialized W Register
RESET SYSTEM BLOCK DIAGRAM
Manual”.
Regulator
RESET Instruction
Internal
Sleep or Idle
Illegal Opcode
Module
this
WDT
Trap Conflict
Refer
V
DD
Detect
Glitch Filter
Rise
to
group
the
BOR
POR
All types of device Reset will set a corresponding status
bit in the RCON register to indicate the type of Reset
(see Register 5-1). A POR will clear all bits except for
the POR bit (RCON<0>), which is set. The user can set
or clear any bit at any time during code execution. The
RCON bits only serve as status bits. Setting a particular
Reset status bit in software does not cause a device
Reset to occur.
The RCON register also has other bits associated with
the Watchdog Timer and device power-saving states.
The function of these bits is discussed in other sections
of this manual.
Note:
Note:
Refer to the specific peripheral or CPU
section of this manual for register Reset
states.
The status bits in the RCON register
should be cleared after they are read so
that the next RCON register value after a
device Reset will be meaningful.
SYSRST
DS70287A-page 73