STE10-100A STMicroelectronics, STE10-100A Datasheet - Page 20
STE10-100A
Manufacturer Part Number
STE10-100A
Description
Pci 10/100 Ethernet Controller With Integrated Phy
Manufacturer
STMicroelectronics
Datasheet
1.STE10-100A.pdf
(82 pages)
- Current page: 20 of 82
- Download datasheet (795Kb)
Functional description
3.5
3.5.1
20/82
Network operation
MAC operation
The MAC (Media access control) portion of STE10/100A incorporates the essential protocol
requirements for operating as an IEEE802.3 and ethernet compliant node.
Format
Table 2.
1. If padding is disabled (TDES1 bit 23), the data field may be shorter than 46 bytes
Transmit data encapsulation
The differences between transmit data encapsulation and a MAC frame while operating in
100BASE-TX mode are listed as follows:
Receive data decapsulation
When operating in 100BASE-TX mode the STE10/100A detects a JK code in a preamble as
well as a TR code at the packet end. If a JK code is not detected, the STE10/100A will abort
the reception of the frame and wait for a new JK code detection. If a TR code is not
detected, the STE10/100A will report a CRC error.
Deferring
The inter-frame gap (IFG) time is divided into two parts:
Preamble
Start frame diameter
Destination address
Source address
Length/type
Data
CRC
–
–
–
–
The first byte of the preamble is replaced by the JK code according to IEE802.3u,
clause 24.
After the CRC field of the MAC frame, the STE10/100A will insert the TR code
according to IEE802.3u, clause 24.
FG1 time (64-bit time): If a carrier is detected on the medium during this time, the
STE10/100A will reset the IFG1 time counter and restart to monitor the channel for
an idle again.
IFG2 time (32-bit time): After counting the IFG2 time the STE10/100A will access
the channel even though a carrier has been sensed on the network.
Field
Format
A 7-byte field of (10101010b)
A 1-byte field of (10101011b)
A 6-byte field
A 6-byte field
A 2-byte field indicated the frame is in IEEE802.3 format or
ethernet format.
IEEE802.3 format: 0000H ~ 05DCH for length field
Ethernet format: 05DD ~ FFFFH for type field
46
A 32-bit cyclic redundancy code for error detection
(1)
~ 1500 bytes of data information
Description
STE10/100A
Related parts for STE10-100A
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
WiFi / 802.11 Modules & Development Tools Eval Board for STE10
Manufacturer:
STMicroelectronics
Part Number:
Description:
STE10/100A - PCI 10/100 ETHERNET CONTROLLER WITH PHY DATASHEET
Manufacturer:
STMicroelectronics
Part Number:
Description:
STE10-100A - PCI 10-100 ETHERNET CONTROLLER WITH PHY DATASHEET
Manufacturer:
STMicroelectronics
Part Number:
Description:
IC CTRLR PCI ETHERNET 128-PQFP
Manufacturer:
STMicroelectronics
Datasheet:
Part Number:
Description:
PCI10-100 ETHERNET CONTROLLER WITH INTEGRATED PHY (5V)
Manufacturer:
STMicroelectronics
Part Number:
Description:
STE10-100A - PCI 10-100 ETHERNET CONTROLLER WITH PHY APPNOTE
Manufacturer:
STMicroelectronics
Part Number:
Description:
STE10-100A EEPROM ACCESS AND PROGRAMMING
Manufacturer:
STMicroelectronics
Datasheet:
Part Number:
Description:
STMicroelectronics [RIPPLE-CARRY BINARY COUNTER/DIVIDERS]
Manufacturer:
STMicroelectronics
Datasheet:
Part Number:
Description:
STMicroelectronics [LIQUID-CRYSTAL DISPLAY DRIVERS]
Manufacturer:
STMicroelectronics
Datasheet:
Part Number:
Description:
BOARD EVAL FOR MEMS SENSORS
Manufacturer:
STMicroelectronics
Datasheet:
Part Number:
Description:
NPN TRANSISTOR POWER MODULE
Manufacturer:
STMicroelectronics
Datasheet:
Part Number:
Description:
TURBOSWITCH ULTRA-FAST HIGH VOLTAGE DIODE
Manufacturer:
STMicroelectronics
Datasheet: