TMPM380FWDFG Toshiba, TMPM380FWDFG Datasheet - Page 48

• Manufacturer Part Number: TMPM380FWDFG
• Manufacturer: Toshiba

Specifications of TMPM380FWDFG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 128K
• Rom Type: Flash
• Ram (kbytes): 12K
• Number Of Pins: 100
• Package: QFP(14×20)
• Vcc: 5V
• Cpu Mhz: 40
• Ssp (ch) Spi: 2
• I2c/sio (ch): 2
• Uart/sio (ch): 5
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: N
• Cs/wait Controller (ch): -
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: -
• 12-bit Ad Converter: 18
• 16-bit Timer / Counter: 8
• Motor / Igbt Control: Y
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: Y
• Hardware Cec Controller: -
• Comparators: -
• Low-voltage Detector: Y
• Etm Hardware Trace: 2-bit

6.5.4
6.5.5
6.5.6
(Note)
(Note)
IDLE mode. When the IDLE mode is entered, peripheral functions for which operation in the IDLE
mode is disabled stop operation and hold the state at that time.
see the chapter on each peripheral function.
mode, the device returns to the preceding mode of the SLEEP mode and starts operation.
starts operation.
shows the pin status in the STOP mode.
Only the CPU is stopped in this mode.
Each peripheral function has one bit in its control register for enabling or disabling operation in the
The following peripheral functions can be enabled or disabled in the IDLE mode. For setting details,
The internal low-speed oscillator, real time clock and RMC can operate. By releasing the SLEEP
All the internal circuits including the internal oscillator are brought to a stop.
By releasing the STOP mode, the device returns to the preceding mode of the STOP mode and
The STOP mode enables to select the pin status by setting the CGSTBYCR<DRVE>.Table 6-5
IDLE Mode
SLEEP Mode
STOP Mode
When PB4 is configured as a debug function pin, it prevents the low power
consumption mode from being fully effective. Configure PB4 to function as a
general-purpose port if the debug function is not used.
When PB4 is configured as a debug function pin, it prevents the low power
consumption mode from being fully effective. Configure PB4 to function as a
general-purpose port when the debug function is not used.
16-bit timer/event counter (TMRB)
16-bit multi purpose timer counter (MPT : except PMD function)
Serial channel (SIO)
Serial bus interface (SBI)
AD converter (ADC)
Watchdog timer (WDT)
PLL
TMPM380/M382 - 17 / 24
TMPM380/M382