DS80CH11 Maxim, DS80CH11 Datasheet - Page 69
![no-image](/images/no-image-200.jpg)
DS80CH11
Manufacturer Part Number
DS80CH11
Description
The system energy manager is a highly integrated microcontroller that provides several key features for systems including key scanning and control, battery and power management, as well as two 2-Wire serial I/O Ports
Manufacturer
Maxim
Datasheet
1.DS80CH11.pdf
(88 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
DS80CH11
Manufacturer:
DALLAS
Quantity:
20 000
Company:
Part Number:
DS80CH11-E02
Manufacturer:
NEC
Quantity:
2 057
Part Number:
DS80CH11-E02
Manufacturer:
DALLAS
Quantity:
20 000
amplifier by setting the XTOFF bit (PMR.3) to a 1. This
can only be done when XT/RG = 0.
When changing the clock source, the selection will take
effect after a one instruction cycle delay. This applies to
changes from crystal to ring and vise versa. However,
this assumes that the crystal amplifier is running. In
most cases, when the ring is active, software previously
disabled the crystal to save power. If ring operation is
being used and the system must switch to crystal opera-
tion, the crystal must first be enabled. Set the XTOFF bit
to a 0. At this time, the crystal oscillation will begin. The
SEM then provides a warm–up delay to make certain
that the frequency is stable. Hardware will set the
XTUP bit (STATUS.4) to a 1 when the crystal is ready for
use. Then software should write XT/RG to a 1 to begin
operating from the crystal. Hardware prevents writing
XT/RG to a 1 before XTUP = 1. The delay between
XTOFF = 0 and XTUP = 1 will be 65,536 crystal clocks.
Switchback has no effect on the clock source. If soft-
ware selects a reduced clock divider and enables the
ring, a Switchback will only restore the divider speed.
The ring will remain as the time base until altered by soft-
ware. If there is serial activity, Switchback usually
occurs with enough time to create proper baud rates.
This is not true if the crystal is off and the CPU is running
from the ring. If sending a serial character that wakes
the system from crystaless Slow Clock Mode, then it
should be a dummy character of no importance with a
subsequent delay for crystal startup.
The flow chart in Figure 12–1 illustrates a typical deci-
sion set associated with Slow Clock Mode.
011200 69/88
DS80CH11