ST72334J4 STMicroelectronics, ST72334J4 Datasheet - Page 28

• Manufacturer Part Number: ST72334J4
• Description: 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY,ADC, 16-BIT TIMERS, SPI, SCI INTERFACES
• Manufacturer: STMicroelectronics

Specifications of ST72334J4

• Clock Sources: crystal/ceramic resonator oscillators or RC oscillators, external clock, backup Clock Security System
• 4 Power Saving Modes: Halt, Active-Halt, Wait and Slow
• Two 16-bit Timers With: 2 input captures (only one on timer A), 2 output compares (only one on timer A), External clock input on timer A, PWM and Pulse generator modes

ST72334J/N, ST72314J/N, ST72124J
9.2 RESET SEQUENCE MANAGER (RSM)
9.2.1 Introduction
The reset sequence manager includes three RE-
SET sources as shown in
These sources act on the RESET pin and it is al-
ways kept low during the delay phase.
The RESET service routine vector is fixed at ad-
dresses FFFEh-FFFFh in the ST7 memory map.
The basic RESET sequence consists of 3 phases
as shown in
Figure 15. Reset Block Diagram
28/153
External RESET source pulse
Internal LVD RESET (Low Voltage Detection)
Internal WATCHDOG RESET
Delay depending on the RESET source
4096 CPU clock cycle delay
RESET vector fetch
RESET
Figure
14:
Figure
V
DD
R
ON
15:
f
CPU
The 4096 CPU clock cycle delay allows the oscil-
lator to stabilise and ensures that recovery has
taken place from the Reset state.
The RESET vector fetch phase duration is 2 clock
cycles.
Figure 14. RESET Sequence Phases
DELAY
4096 CLOCK CYCLES
INTERNAL RESET
RESET
WATCHDOG RESET
LVD RESET
INTERNAL
RESET
VECTOR
FETCH