ST7MC1K4 STMicroelectronics, ST7MC1K4 Datasheet - Page 108

• Manufacturer Part Number: ST7MC1K4
• Description: 8-BIT MCU WITH NESTED INTERRUPTS, FLASH, 10-BIT ADC,BRUSHLESS MOTOR CONTROL, 5 TIMERS, SPI, LINSCI(TM)
• Manufacturer: STMicroelectronics

Specifications of ST7MC1K4

• Hdflash Endurance: 100 cycles, data retention
• Clock Sources: crystal/ceramic resonator oscillators and by-pass for external clock, clock security system.
• Four Power Saving Modes: Halt, Active-Halt, Wait and Slow
• Main Clock Controller With: Real time base, Beep and Clock-out capabilities
• Two 16-bit Timers With: 2 input captures, 2 output compares, external clock input, PWM and pulse generator modes
• 8-bit Pwm Auto-reload Timer With: 2 input captures, 4 PWM outputs, output compare and time base interrupt, external clock with event detector

ST7MC1xx/ST7MC2xx
LINSCI™ SERIAL COMMUNICATION INTERFACE (cont’d)
10.5.4 General Description
The interface is externally connected to another
device by two pins:
– TDO: Transmit Data Output. When the transmit-
– RDI: Receive Data Input is the serial data input.
Through these pins, serial data is transmitted and
received as characters comprising:
– An Idle Line prior to transmission or reception
– A start bit
– A data word (8 or 9 bits) least significant bit first
– A Stop bit indicating that the character is com-
This interface uses three types of baud rate gener-
ator:
108/309
1
ter is disabled, the output pin returns to its I/O
port configuration. When the transmitter is ena-
bled and nothing is to be transmitted, the TDO
pin is at high level.
Oversampling techniques are used for data re-
covery by discriminating between valid incoming
data and noise.
plete
– A conventional type for commonly-used baud
– An extended type with a prescaler offering a very
– A LIN baud rate generator with automatic resyn-
rates
wide range of baud rates even with non-standard
oscillator frequencies
chronization