STM32F205ZG STMicroelectronics, STM32F205ZG Datasheet - Page 33
![no-image](/images/manufacturer_photos/0/6/637/stmicroelectronics_sml.jpg)
STM32F205ZG
Manufacturer Part Number
STM32F205ZG
Description
High-performance ARM Cortex-M3 MCU with 1 Mbyte Flash, 120 MHz CPU, ART Accelerator
Manufacturer
STMicroelectronics
Datasheet
1.STM32F205VE.pdf
(170 pages)
Specifications of STM32F205ZG
10/100 Ethernet Mac With Dedicated Dma
supports IEEE 1588v2 hardware, MII/RMII
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
STM32F205ZG
Manufacturer:
ST
Quantity:
20 000
Company:
Part Number:
STM32F205ZGT6
Manufacturer:
STMicroelectronics
Quantity:
11
Company:
Part Number:
STM32F205ZGT6
Manufacturer:
STMicroelectronics
Quantity:
10 000
STM32F205xx, STM32F207xx
2.2.30
2.2.31
2.2.32
suspend/resume. The USB OTG full-speed controller requires a dedicated 48 MHz clock
that is generated by a PLL connected to the HSE oscillator. The major features are:
●
●
●
●
●
●
●
●
●
●
Audio PLL (PLLI2S)
The devices feature an additional dedicated PLL for audio I
achieve error-free I
performance, while using USB peripherals.
The PLLI2S configuration can be modified to manage an I
disabling the main PLL (PLL) used for CPU, USB and Ethernet interfaces.
The audio PLL can be programmed with very low error to obtain sampling rates ranging
from 8 kHz to 192 kHz.
In addition to the audio PLL, a master clock input pin can be used to synchronize the I2S
flow with an external PLL (or Codec output).
Digital camera interface (DCMI)
The camera interface is not available in STM32F205xx devices.
STM32F207xx products embed a camera interface that can connect with camera modules
and CMOS sensors through an 8-bit to 14-bit parallel interface, to receive video data. The
camera interface can sustain up to 27 Mbyte/s at 27 MHz or 48 Mbyte/s at 48 MHz. It
features:
●
●
●
●
●
True random number generator (RNG)
All STM32F2xxx products embed a true RNG that delivers 32-bit random numbers
produced by an integrated analog circuit.
Combined Rx and Tx FIFO size of 1024× 35 bits with dynamic FIFO sizing
Supports the session request protocol (SRP) and host negotiation protocol (HNP)
6 bidirectional endpoints
12 host channels with periodic OUT support
Internal FS OTG PHY support
External FS OTG PHY support through an I
External HS or HS OTG operation supporting ULPI in SDR mode. The OTG PHY is
connected to the microcontroller ULPI port through 12 signals. It can be clocked using
the 60 MHz output.
Internal USB DMA
HNP/SNP/IP inside (no need for any external resistor)
For OTG/Host modes, a power switch is needed in case bus-powered devices are
connected
Programmable polarity for the input pixel clock and synchronization signals
Parallel data communication can be 8-, 10-, 12- or 14-bit
Supports 8-bit progressive video monochrome or raw Bayer format, YCbCr 4:2:2
progressive video, RGB 565 progressive video or compressed data (like JPEG)
Supports continuous mode or snapshot (a single frame) mode
Capability to automatically crop the image
2
S sampling clock accuracy without compromising on the CPU
Doc ID 15818 Rev 8
2
C connection
2
S sample rate change without
2
S application. It allows to
Description
33/170