SAM9X35 Atmel Corporation, SAM9X35 Datasheet - Page 493

• Manufacturer Part Number: SAM9X35
• Manufacturer: Atmel Corporation

Specifications of SAM9X35

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 105
• Ext Interrupts: 105
• Usb Transceiver: 3
• Usb Speed: Hi-Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 3
• Uart: 7
• Can: 2
• Lin: 4
• Ssc: 1
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 12
• Adc Resolution (bits): 10
• Adc Speed (ksps): 440
• Resistive Touch Screen: Yes
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: DDR/LPDDR, SDRAM/LPSDR
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

Figure 31-14. DMAC Transfer Replay Mode is Enabled for the Source and Contiguous Destination Address
11055B–ATARM–22-Sep-11
11055B–ATARM–22-Sep-11
Multi-buffer DMAC Transfer with Linked List for Source and Contiguous Destination Address (Row 2)
Buffer Transfer Complete
interrupt generated here
1. Read the Channel Enable register to choose a free (disabled) channel.
2. Set up the linked list in memory. Write the control information in the
LLI.DMAC_CTRLAx and LLI.DMAC_CTRLBx register location of the buffer descriptor
for each LLI in memory for channel x. For example, in the register, you can program the
following:
a. Set up the transfer type (memory or non-memory peripheral for source and desti-
b. Set up the transfer characteristics, such as:
– i. Transfer width for the source in the SRC_WIDTH field.
– ii. Transfer width for the destination in the DST_WIDTH field.
– iii. Source AHB master interface layer in the SIF field where source resides.
– iv. Destination AHB master interface layer in the DIF field where destination resides.
Channel Disabled by
nation) and flow control device by programming the FC of the DMAC_CTRLBx
register.
Buffer Complete interrupt
hardware
generated here
yes
Contiguous mode for DADDRx
HDMA State Machine Table?
Replay mode for SADDRx,
Stall until STALLED field is
cleared by software writing
DMA_EBCIMR[x]=1?
Channel Enabled by
Is HDMA in Row1of
CTRLAx, CTRLBx
KEEPON Field
Buffer Transfer
software
no
yes
no
SAM9X35
SAM9X35
493
493