SAM3N2A Atmel Corporation, SAM3N2A Datasheet - Page 148

• Manufacturer Part Number: SAM3N2A
• Manufacturer: Atmel Corporation

Specifications of SAM3N2A

• Flash (kbytes): 128 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 48 MHz
• Cpu: Cortex-M3
• # Of Touch Channels: 23
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 47
• Ext Interrupts: 47
• Quadrature Decoder Channels: 2
• Usb Speed: No
• Usb Interface: No
• Spi: 2
• Twi (i2c): 2
• Uart: 3
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

10.18.11 WFE
10.18.11.1
10.18.11.2
10.18.11.3
10.18.11.4
148
WFE
SAM3N
Syntax
Operation
Condition flags
Examples
; Wait for event
Wait For Event.
where:
cond
WFE is a hint instruction.
If the event register is 0, WFE suspends execution until one of the following events occurs:
If the event register is 1, WFE clears it to 0 and returns immediately.
For more information see
This instruction does not change the flags.
• an exception, unless masked by the exception mask registers or the current priority level
• an exception enters the Pending state, if SEVONPEND in the System Control Register is set
• a Debug Entry request, if Debug is enabled
• an event signaled by a peripheral or another processor in a multiprocessor system using the
SEV instruction.
WFE{cond}
is an optional condition code, see
“Power management” on page
“Conditional execution” on page
72.
11011A–ATARM–04-Oct-10
84.