AT32UC3L0128 Atmel Corporation, AT32UC3L0128 Datasheet - Page 719

• Manufacturer Part Number: AT32UC3L0128
• Manufacturer: Atmel Corporation

Specifications of AT32UC3L0128

• Flash (kbytes): 128 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 50 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 17
• Hardware Qtouch Acquisition: Yes
• Max I/o Pins: 36
• Ext Interrupts: 36
• Usb Speed: No
• Usb Interface: No
• Spi: 5
• Twi (i2c): 2
• Uart: 4
• Lin: 4
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 12
• Adc Speed (ksps): 460
• Analog Comparators: 8
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.62 to 3.6
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 6
• Output Compare Channels: 18
• Input Capture Channels: 12
• Pwm Channels: 35
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

30. aWire UART (AW)
30.1
30.2
30.3
Figure 30-1. aWire Debug Interface Block Diagram
32145A–12/2011
Features
Overview
Block Diagram
AW User Interface
RW
PB
SZ
AW CONTROL
SAB interface
Rev: 2.3.0.0
•
•
If the AW is not used for debugging, the aWire UART can be used by the user to send or receive
data with one start bit, eight data bits, no parity bits, and one stop bit. This can be controlled
through the aWire UART user interface.
This chapter only describes the aWire UART user interface. For a description of the aWire
Debug Interface, please see the Programming and Debugging chapter.
Asynchronous receiver or transmitter when the aWire system is not used for debugging.
One- or two-pin operation supported.
ADDR
SAB
aWire Debug Interface
DATA
CHIP_ERASE command
HALT command
RESET command
Baudrate Detector
AW_ENABLE
UART
CRC
AT32UC3L0128/256
External reset
Manager
Controller
Power
Reset
Flash
filter
CPU
RESET_N
719