PSB2163T-V31TR Infineon Technologies, PSB2163T-V31TR Datasheet - Page 228

• Manufacturer Part Number: PSB2163T-V31TR
• Description: IC AUDIO RINGING CODEC 28-PDSO
• Manufacturer: Infineon Technologies
• Series: ARCOFI®r

Specifications of PSB2163T-V31TR

• Function: CODEC Filter
• Interface: IOM-2, PCI, Serial
• Number Of Circuits: 1
• Voltage - Supply: 5V
• Current - Supply: 900µA
• Power (watts): 1mW
• Operating Temperature: -25°C ~ 80°C
• Mounting Type: Surface Mount
• Package / Case: DSO-28
• Includes: Activation and Deactivation, B-Channel and D-Channel HDLC Controllers, D-Channel Priority Handler, Monitor Channel Handler
• Lead Free Status / RoHS Status: Request inventory verification / Request inventory verification
• Other names: PSB2163T-V31INTR; PSB2163T-V31TR

5
All information about installing the Evaluation Board ARCOFI-SP, programming the ARCOFI-SP
and the other modules of the set-up in various configurations, are described in this chapter.
For programming the set-up using the menu software track files see chapter 7. These
configurations can also be programmed by the ARCOS-SP Plus software. For more details on
ARCOS-SP Plus refer to “ARCOS-SP Plus User Manual V 1.0”.
5.1
There are three switches at the Evaluation Board ARCOFI-SP. The push button switch SW3 is to
reset the whole circuitry by resetting the ARCOFI-SP. Switches S1 and S2 of SW1 select the
interface mode (IOM-2 TE or IOM-2 NON TE) and the hardware address (AD0 or AD1) of the
ARCOFI-SP respectively. The particular settings are depicted in the table below.
S1
ON
ON
OFF
OFF
5.2
One jumper J1 is used to select the power supply: If the power is taken from the PC, jumper J1 is
set to position 1-2 (towards SW3). If an external power source is connected via the external power
supply connector ST1, jumper J1 is set to position 2-3 (towards ST1).
5.3
The Evaluation Board ARCOFI-SP can be used in two different interface modes:
• IOM-2 TE; terminal timing (1.536 MHz DCL))
• IOM-2 NON TE; non terminal timing (4.096 MHz DCL)
Attention:
When using the non terminal timing mode (IOM-2 NON TE) the timeslot must be determined by
hardwiring the pins SD, SC, SB (pins 2,3,4). By default, these pins are not connected on the
SIPB 5133-SP Evaluation Board. Refer to the User’s Manual, chapter 2.3.2 “IOM-2 Frame
Structure and Timing Modes” for more detailed information.
Before starting the initialization procedure using the menu software, please recheck the
configuration and the jumpers on the modules to succeed in programming. For IOM-2 NON TE
mode, one of the eight timeslot has to be set. Note that the Evaluation Board ARCOFI-SP has
always to be connected to that service access connector of the mainboard that leads to the audio
interface module (see also figure 1).
Semiconductor Group
Operational Information
Setting Switches
Setting Jumper
Configuring the Evaluation Board ARCOFI
S2
ON
OFF
ON
OFF
Function
IOM-2 TE mode (A-chip)
IOM-2 TE mode (B-chip)
IOM-2 NON TE mode (A-chip)
IOM-2 NON TE mode (B-chip)
227
®
-SP
SIPB 5133-SP