101-1006 Rabbit Semiconductor, 101-1006 Datasheet - Page 21

• Manufacturer Part Number: 101-1006
• Description: MODULE POWERCORE FLEX 3800
• Manufacturer: Rabbit Semiconductor

Specifications of 101-1006

• Module/board Type: MPU Core Module
• For Use With/related Products: RCM3800
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

2.3 Starting Dynamic C
Once the PowerCore module is connected as described in the preceding pages, start
Dynamic C by double-clicking on the Dynamic C icon or by double-clicking on
dcrabXXXX.exe in the Dynamic C root directory, where XXXX are version-specific
characters. Dynamic C uses the serial port on your PC that you specified during
installation.
If you are using a USB port to connect your computer to the PowerCore module, go to the
Options > Project Options
Communications
2.4 Run a Sample Program
Use the
SAMPLES
dow will open on your PC and will display a small square bouncing around in a box.
If Dynamic C appears to compile the BIOS successfully, but you then receive a communi-
cation error message when you compile and load a sample program, it is possible that your
PC cannot handle the higher program-loading baud rate. Try changing the maximum
download rate to a slower baud rate as follows.
• Locate the
If a program compiles and loads, but then loses target communication before you can
begin debugging, it is possible that your PC cannot handle the default debugging baud
rate. Try lowering the debugging baud rate as follows.
• Locate the
If Dynamic C cannot find the target system (error message
Detected.")
• Check that the PowerCore module is powered correctly —
• Check to make sure you are using the
• Check both ends of the programming cable to ensure that they are firmly plugged into
• Ensure that the PowerCore module is firmly and correctly installed in its socket on the
• Select a different COM port within Dynamic C. From the
User’s Manual
Communications
Communications
the Prototyping Board should be lit when the
ing Board and the wall transformer is plugged in
programming cable.
the PC and the programming port on the PowerCore module.
Prototyping Board.
Project Options
then click OK. Press
still reports it is unable to locate the target system, repeat the above steps until you locate
the active COM port.
File
folder. Press function key
menu to open the sample program
Serial Options
Serial Options
:
tab.
, then select
menu. Select a slower Max download baud rate.
menu. Choose a lower debug baud rate.
<Ctrl-Y>
dialog box and select “Use USB to Serial Converter” on the
dialog in the Dynamic C
dialog in the Dynamic C
Communications
to force Dynamic C to recompile the BIOS. If Dynamic C
F9
to compile and run the program. The
PROG
PowerCore module
.
PONG.C
connector, not the
. Select another COM port from the list,
Options > Project Options >
Options > Project Options >
, which is in the Dynamic C
"No Rabbit Processor
Options
the red and yellow LEDs on
is mounted on the Prototyp-
DIAG
menu, select
connector, on the
STDIO
win-
13