101-1006 Rabbit Semiconductor, 101-1006 Datasheet - Page 111

• Manufacturer Part Number: 101-1006
• Description: MODULE POWERCORE FLEX 3800
• Manufacturer: Rabbit Semiconductor

Specifications of 101-1006

• Module/board Type: MPU Core Module
• For Use With/related Products: RCM3800
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

•
6.7 Where Do I Go From Here?
If there are any problems at this point:
• Use the Dynamic C
• Check the Rabbit Semiconductor Technical Bulletin Board at
• Use the Technical Support e-mail form at www.rabbit.com/support/.
If the sample programs ran fine, you are now ready to go on.
Additional sample programs are described in the Dynamic C TCP/IP User’s Manual.
Please refer to the Dynamic C TCP/IP User’s Manual to develop your own applications.
An Introduction to TCP/IP provides background information on TCP/IP, and is available
on the CD and on our
User’s Manual
TELNET.c
out Serial Port E. It uses a digital input to indicate that the TCP/IP connection should be
closed and a digital output to toggle an LED to indicate that there is an active connection.
PC Setup
Connect PC to PowerCore Prototyping Board
Once you have compiled and run the sample program, start a Telnet session on your PC
(
TCPCONFIG 1
otherwise use the TCP/IP settings you entered in the
Now look at LED DS5 on the Prototyping Board—a blinking LED indicates that there
is an active Telnet connection. You can type a message in the Telnet window, then view
the message using a PC serial utility such as Tera Term. Press switch S2 on the Proto-
typing Board to close the Telnet connection; DS5 should stop blinking, indicating that
the Telnet connection has been closed.
www.rabbit.com/support/bb/.
Start > Run telnet 10.10.6.100
1. Start up a PC serial utility such as Tera Term or Hyperterminal.
2. Configure the serial parameters for a baud rate of 19200, 8 bits, no parity and 1 stop bit.
3. Enable the “Local Echo” option.
4. Enable the option to append linefeeds to incoming and outgoing messages.
1. Connect PC Tx to pin 4 on header J1 of the Prototyping Board (RXF).
2. Connect PC Rx to pin 6 on header J1 of the Prototyping Board (TXF).
3. Connect PC GND to pin 9 on header J1 of the Prototyping Board (GND).
NOTE: If you purchased your PowerCore module through a distributor or through a
Rabbit Semiconductor partner, contact the distributor or partner first for technical
support.
—This sample program takes anything that comes in on a port and sends it
macro in the sample program, the IP address is 10.10.6.100 as shown;
Web
Help
site.
menu to get further assistance with Dynamic C.
). As long as you have not modified the
TCP_CONFIG.LIB
library.
103