ICS952906AFLF IDT, Integrated Device Technology Inc, ICS952906AFLF Datasheet - Page 20

• Manufacturer Part Number: ICS952906AFLF
• Description: IC TIMING CTRL HUB P4 48-SSOP
• Manufacturer: IDT, Integrated Device Technology Inc
• Type: Timing Control Hubr

Specifications of ICS952906AFLF

• Input: Crystal
• Output: Clock
• Frequency - Max: 460MHz
• Voltage - Supply: 3.135 V ~ 3.465 V
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 48-SSOP
• Frequency-max: 460MHz
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 952906AFLF

1236A—08/06/07
The I/O pins designated by (input/output) serve as dual
signal functions to the device. During initial power-up, they
act as input pins. The logic level (voltage) that is present on
these pins at this time is read and stored into a 5-bit internal
data latch. At the end of Power-On reset, (see AC
characteristics for timing values), the device changes the
mode of operations for these pins to an output function. In
this mode the pins produce the specified buffered clocks to
external loads.
To program (load) the internal configuration register for
these pins, a resistor is connected to either the VDD (logic 1)
power supply or the GND (logic 0) voltage potential. A 10
Kilohm (10K) resistor is used to provide both the solid CMOS
programming voltage needed during the power-up
programming period and to provide an insignificant load on
the output clock during the subsequent operating period.
Shared Pin Operation -
Input/Output Pins
Integrated
Circuit
Systems, Inc.
Device
Pad
Programming
Header
Via to Gnd
Series Term. Res.
Fig. 1
20
Figure 1 shows a means of implementing this function
when a switch or 2 pin header is used. With no jumper is
installed the pin will be pulled high. With the jumper in
place the pin will be pulled low. If programmability is not
necessary, than only a single resistor is necessary. The
programming resistors should be located close to the series
termination resistor to minimize the current loop area. It is
more important to locate the series termination resistor
close to the driver than the programming resistor.
8.2K W
2K W
Clock trace to load
Via to
VDD
ICS952906A