SR1530HCLR Intel (CPU), SR1530HCLR Datasheet - Page 61

• Manufacturer Part Number: SR1530HCLR
• Manufacturer: Intel (CPU)

Specifications of SR1530HCLR

• Lead Free Status / RoHS Status: Not Compliant

Intel
Revision 2.2
®
•
•
•
•
•
•
•
•
•
Server Board S5000VCL TPS
When adding or removing components or peripherals from the server board, AC power
must be removed. With AC power plugged into the server board, 5-volt standby is still
present even though the server board is powered off.
When two processors are installed, both must be of identical revision, core voltage,
and bus/core speed. Mixed processor steppings is supported. However, the stepping
of one processor can not be greater then one stepping back of the other.
Processors must be installed in order. CPU 1 is located near the edge of the server
board and must be populated to operate the board.
Only fully buffered DIMMs (FBD) are supported on this server board. For a list of
supported memory for this server board, see the Intel
Tested Memory List.
For a list of Intel supported operating systems, add-in cards, and peripherals for this
server board, see the Intel
Only Dual-Core Intel
Xeon
supported on this server board. Previous generation Intel
supported.
Removing AC power before performing the CMOS clear operation will cause the
system to automatically power up and immediately power down after the procedure is
followed and AC power is re-applied. If this happens remove the AC power cord again,
wait 30 seconds, and then reconnect the AC power cord. Power up the system and
proceed to the <F2> BIOS setup utility to reset desired settings.
Normal BMC functionality is disabled with the force BMC update jumper set to the
“enabled” position (pins 2-3). The server should never be run with the BMC force
update jumper set in this position and should only be used when the standard firmware
update process fails. This jumper should remain in the default (disabled) position (pins
1-2) when the server is running normally.
When performing a BIOS update, the BIOS select jumper must be set to its default
position (pins 2-3).
Appendix A: Integration and Usage Tips
®
processor 5300 series, with system bus speeds of 1066, or 1333 MHz are
−
For a complete list of supported processors, see the following link:
http://support.intel.com/support/motherboards/server/S5000VCL
®
Xeon
Intel order number: D64569-006
®
®
Server Board S5000VCL Tested Hardware and OS List.
processors 5100 series or low- voltage Quad-Core Intel
Appendix A: Integration and Usage Tips
®
Server Board S5000VCL
®
Xeon
®
processors are not
®
51