85134F AGILENT TECHNOLOGIES, 85134F Datasheet - Page 28

• Manufacturer Part Number: 85134F
• Description: Cable Sets
• Manufacturer: AGILENT TECHNOLOGIES

Specifications of 85134F

• Kit Contents: 2 Cables
• Peak Reflow Compatible (260 C): No
• Cable Length: 24.75"
• Leaded Process Compatible: No
• Connector Type B: 3.5mm Female
• Connector Type A: 2.4mm Female
• Lead Length: 62.9cm
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Use, Maintenance, and Care of the Cables
Making Connections
7. Push the connectors straight together. Do not twist or screw the connectors together.
8. Engage the connector nut (of the connector with the retracted sleeve) over the threads
9. Do not overtighten this connection. A connection in which the outer conductors make
10.Make sure the connectors are properly supported. Relieve any side pressure on the
Final Connection Using a Torque Wrench
Use a torque wrench to make a final connection.
torque wrench recommended for use with the calibration kit. A torque wrench is included
in the calibration kit. Refer to
ordering information.
Table 3-1
Using a torque wrench guarantees that the connection is not too tight, preventing possible
connector damage. It also guarantees that all connections are equally tight each time.
Prevent the rotation of anything other than the connector nut that you are tightening. It
may be possible to do this by hand if one of the connectors is fixed (as on a test port).
However, it is recommended that you use an open-end wrench to keep the body of the
device from turning.
1. Position both wrenches within 90 degrees of each other before applying force. See
3-14
Connector Type
2.4 mm and 3.5 mm
7 mm
of the other connector (the connector with the extended sleeve). Turn only the connector
nut. Let the connector nut pull the two connectors straight together.
gentle contact at all points on both mating surfaces is sufficient. Very light finger
pressure is enough to accomplish this.
connection from long or heavy devices or cables.
Figure
lifting action which can misalign and stress the connections of the devices involved.
This is especially true when several devices are connected together.
3-5. Wrenches opposing each other (greater than 90 degrees apart) will cause a
Torque Wrench Information
Torque Setting
90 N-cm (8 in-lb)
136 N-cm (12 in-lb)
Table 4-1 on page 4-4
Torque Tolerance
±9.0 N-cm (±0.8 in-lb)
±13.6 N-cm (±1.2 in-lb)
Table 3-1
for replacement part number and
provides information about the
85134E/F/H & 85135E/F