85134F AGILENT TECHNOLOGIES, 85134F Datasheet - Page 16

• Manufacturer Part Number: 85134F
• Description: Cable Sets
• Manufacturer: AGILENT TECHNOLOGIES

Specifications of 85134F

• Kit Contents: 2 Cables
• Peak Reflow Compatible (260 C): No
• Cable Length: 24.75"
• Leaded Process Compatible: No
• Connector Type B: 3.5mm Female
• Connector Type A: 2.4mm Female
• Lead Length: 62.9cm
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Use, Maintenance, and Care of the Cables
Electrostatic Discharge
Electrostatic Discharge
Protection against ESD (electrostatic discharge) is essential while connecting, inspecting,
or cleaning connectors attached to a static-sensitive circuit (such as those found in test
sets).
Static electricity can build up on your body and can easily damage sensitive internal
circuit elements when discharged. Static discharges too small to be felt can cause
permanent damage. Devices such as calibration components and devices under test
(DUTs), can also carry an electrostatic charge. To prevent damage to the test set,
components, and devices:
• always wear a grounded wrist strap having a 1 MΩ resistor in series with it when
• always use a grounded, conductive table mat while making connections.
• always wear a heel strap when working in an area with a conductive floor. If you are
• always ground yourself before you clean, inspect, or make a connection to a
• always ground the center conductor of a test cable before making a connection to the
Refer to
Figure 3-1. ESD Protection Setup
3-2
handling components and devices or when making connections to the test set.
uncertain about the conductivity of your floor, wear a heel strap.
static-sensitive device or test port. You can, for example, grasp the grounded outer shell
of the test port or cable connector briefly.
analyzer test port or other static-sensitive device. This can be done as follows:
1. Connect a short (from your calibration kit) to one end of the cable to short the center
2. While wearing a grounded wrist strap, grasp the outer shell of the cable connector.
3. Connect the other end of the cable to the test port.
4. Remove the short from the cable.
conductor to the outer conductor.
Chapter 4
for part numbers and instructions for ordering ESD protection devices.
85134E/F/H & 85135E/F