HSC-ADC-FIFO5-INTZ Analog Devices Inc, HSC-ADC-FIFO5-INTZ Datasheet - Page 13

• Manufacturer Part Number: HSC-ADC-FIFO5-INTZ
• Description: Interposer Quad/octal ADCs
• Manufacturer: Analog Devices Inc

Specifications of HSC-ADC-FIFO5-INTZ

• Accessory Type: ADC Interface Board
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: AD6640
• Lead Free Status / Rohs Status: Supplier Unconfirmed

4.
Make sure that the number of bits matches the resolution of the
converter. All of the supported evaluation boards are MSB
justified, so check the number of bits for the converter starting
with Bit 15 (MSB). Exceptions to this are the AD9280, AD9281,
AD9200, and AD9201. For these four ADCs, check the number
of bits starting with Bit 13.
If a single ADC is being evaluated, check only Channel A and
the appropriate bits under Channel A. If a dual ADC is being
evaluated, check Channel A and Channel B on the Channel
Select screen. (Config > Channel Select).
Step 3a
Choose Config > Bits > Data Bits to open the Bit Mask
screen. Configure the number and location of the data bits
used to calculate the FFTs.
Rev. 0 | Page 13 of 44
HSC-ADC-EVALA-SC/HSC-ADC-EVALA-DC
Step 4
If evaluating a demultiplexed ADC, go to Config > Channel
Select, opening the Channel Select pop-up menu, and check the
Interleaved Data box. This automatically selects both Channel
A and Channel B. When using a dual ADC, select only the
appropriate channel that corresponds to the ADC that is being
evaluated. Channel A is the default selected channel at startup.
Note that Channel A in the software corresponds to Channel 1
on the FIFO schematics and the bottom FIFO (U201) on the
Step 4a