HCTL-2017 Avago Technologies US Inc., HCTL-2017 Datasheet - Page 10

• Manufacturer Part Number: HCTL-2017
• Description: Quadrature Decoder IC,16bit,PDIP
• Manufacturer: Avago Technologies US Inc.

Specifications of HCTL-2017

• Applications: Encoder to Microprocessor
• Interface: 8-Bit Tristate
• Voltage - Supply: 4.5 V ~ 5.5 V
• Package / Case: 16-DIP (0.300", 7.62mm)
• Mounting Type: Through Hole
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 516-2010

Cascade Considerations
The HCTL-2021/2017 cascading system allows for
position reads of more than four bytes. These reads
can be accomplished by latching all the bytes and then
reading the bytes sequentially over the 8-bit bus. It is
assumed here that, externally, a counter followed by a
latch is used to count any count that exceeds 16 bits.
This configuration is compatible with the HCTL-2021/
2017 internal counter/latch combination.
Consider the sequence of events for a read cycle that
starts as the HCTL-2021/2017 internal counter rolls over.
On the rising clock edge, count data is updated in the
internal counter, rolling it over. A count-cascade pulse
(CNT
rising clock edge (t
propagation delays through the external counters and
registers. Meanwhile, with SEL and OE low to start the
read, the internal latches are inhibited at the falling edge
and do not update again till the inhibit is reset.
If the CNT
and this count gets latched a major count error will
Figure 12. Decode and Cascade Output Diagram (4x)
10
CAS
) will be generated with some delay after the
CAS
pulse now toggles the external counter
CHD
). There will be additional
occur. The count error is because the external latches
get updated when the internal latch is inhibited.
Valid data can be ensured by latching the external
counter data when the high byte read is started (SEL
and OE low). This latched external byte corresponds to
the count in the inhibited internal latch. The cascade
pulse that occurs during the clock cycle when the read
begins gets counted by the external counter and is not
lost.
For example, suppose the HCTL-2021/2017 count is at
FFFFh and an external counter is at F0h, with the count
going up. A count occurring in the HCTL-2021/2017 will
cause the counter to roll over and a cascade pulse will
be generated. A read starting on this clock cycle will
show FFFFh from the HCTL-2021/2017. The external
latch should read F0h, but if the host latches the count
after the cascade signal propagates through, the
external latch will read F1h.