V020-E3-2 Omron, V020-E3-2 Datasheet - Page 86

• Manufacturer Part Number: V020-E3-2
• Description: Publications, Books
• Manufacturer: Omron

Specifications of V020-E3-2

• Lead Free Status / RoHS Status: na

3-3-3
Displaying the System Menu Press appropriate touch switches to display the System Menu as mentioned be-
70
Operation modes and the System Menu
Operations with the System Menu
The following gives the procedure to call the System Menu, select the menu items,
and other operations with the System Menu.
Make sure that DIP SW2-3 “Switch to the System Menu enabled/disabled” is set to
OFF (enabled). If the setting is ON (disabled), the System Menu will not be dis-
played by following the procedure given below.
low. The “RUN” LED goes off when the System Menu is displayed.
The NT20S display screen has four touch switches to display the System Menu in
the four corners (about 8 mm x 8 mm size). Press any two of these switches at the
same time to call the System Menu screen.
Note that the touch switches used to call the System Menu are not displayed on
the screen. If a touch switch displayed in a corner is pressed first, the touch switch
will function and the System Menu will not be displayed. To successfully call the
System Menu, first press a corner where no touch key is displayed, and then,
press any other corner regardless of the presence of a touch key.
If a screen has the touch switches registered at all of the four corners, it is impossi-
ble to call the System Menu from the screen.
A “system key” function can be assigned to a touch switch. Pressing the touch
switch so assigned on the screen can easily display the System Menu. For the
relationship between the system key and the touch switch, refer to the “System
key functions” (page 139).
RUN mode
Press any two
of these four
corners at the
same time.
Quit
Transmit Mode
Maintenance mode
[SYSTEM MENU]
Section 3-3