PIC18F85K22-I/PT Microchip Technology, PIC18F85K22-I/PT Datasheet - Page 117

• Manufacturer Part Number: PIC18F85K22-I/PT
• Description: IC, 8BIT MCU, PIC18F, 64MHZ, TQFP-80
• Manufacturer: Microchip Technology
• Series: PIC® XLP™ 18Fr

Specifications of PIC18F85K22-I/PT

• Controller Family/series: PIC18
• No. Of I/o's: 69
• Eeprom Memory Size: 1KB
• Ram Memory Size: 2KB
• Cpu Speed: 64MHz
• No. Of Timers: 8
• Core Size: 8 Bit
• Program Memory Size: 32KB
• Core Processor: PIC
• Speed: 64MHz
• Connectivity: EBI/EMI, I²C, LIN, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, LVD, POR, PWM, WDT
• Number Of I /o: 69
• Program Memory Type: FLASH
• Eeprom Size: 1K x 8
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 24x12b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 80-TQFP
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

7.5
The programming blocks are:
• PIC18FX5K22 and PIC18FX6K22 – 32 words or
• PIC18FX7K22 – 64 words or 128 bytes
Word or byte programming is not supported.
Table writes are used internally to load the holding
registers needed to program the Flash memory. The
number of holding registers used for programming by
the table writes are:
• PIC18FX5K22 and PIC18FX6K22 – 64
• PIC18FX7K22 – 128
Since the Table Latch (TABLAT) is only a single byte, the
TBLWT instruction may need to be executed 64 times for
each programming operation. All of the table write oper-
ations will essentially be short writes because only the
holding registers are written. At the end of updating the
64 or 128 holding registers, the EECON1 register must
be written to in order to start the programming operation
with a long write.
FIGURE 7-5:
 2009-2011 Microchip Technology Inc.
TBLPTR = xxxxx0
64 bytes
Writing to Flash Program Memory
Holding Register
8
TABLE WRITES TO FLASH PROGRAM MEMORY
TBLPTR = xxxxx1
Holding Register
8
Program Memory
TBLPTR = xxxxx2
Write Register
TABLAT
PIC18F87K22 FAMILY
The long write is necessary for programming the
internal Flash. Instruction execution is halted while in a
long write cycle. The long write is terminated by the
internal programming timer.
The EEPROM on-chip timer controls the write time.
The write/erase voltages are generated by an on-chip
charge pump, rated to operate over the voltage range
of the device.
Holding Register
Note:
8
The default value of the holding registers
on device Resets, and after write opera-
tions, is FFh. A write of FFh to a holding
register does not modify that byte. This
means that individual bytes of program
memory may be modified, provided that
the change does not attempt to change
any bit from a ‘0’ to a ‘1’. When modifying
individual bytes, it is not necessary to load
all 64 or 128 holding registers before
executing a write operation.
TBLPTR = xxxx3F
DS39960D-page 117
Holding Register
8