GP1A51HRJ00F Sharp Microelectronics, GP1A51HRJ00F Datasheet - Page 7

• Manufacturer Part Number: GP1A51HRJ00F
• Description: PHOTOINTER OPIC SLOT 3.0MM PCB
• Manufacturer: Sharp Microelectronics
• Series: OPIC™r

Specifications of GP1A51HRJ00F

• Package / Case: PCB Mount
• Sensing Distance: 0.118" (3mm)
• Sensing Method: Transmissive
• Output Configuration: Pull-Up Resistor, Buffer
• Mounting Type: Through Hole
• Current - Supply: 1.7mA
• Voltage - Supply: 4.5 V ~ 17 V
• Response Time: 1µs, 0.05µs
• No. Of Channels: 1
• Input Current: 5mA
• Output Voltage: 4.9V
• Opto Case Style: Through Hole
• No. Of Pins: 5
• Operating Temperature Range: -25°C To +85°C
• Output Type: Transistor
• Maximum Reverse Voltage (emitter): 6 V
• Slot Width: 3 mm
• Aperture Width: 0.5 mm
• Output Device: Photologic, Pull up
• Power Dissipation: 250 mW
• Maximum Fall Time: 500 ns
• Maximum Operating Temperature: + 85 C
• Maximum Rise Time: 500 ns
• Minimum Operating Temperature: - 25 C
• Optocoupler Output Type: Transistor
• Svhc: No SVHC (15-Dec-2010)
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 425-1949-5

■ Design Considerations
● Recommended operating conditions
● Notes about static electricity
● Design guide
● Degradation
Transisiter of detector side in bipolar confi guration may be damaged by static electricity due to its minute
design.
When handing these devices, general countermeasure against static electricity should be taken to avoid
breakdown of devices or degradation of characteristics.
1) Prevention of detection error
2) In order to stabilize power supply line, connect a by-pass capacitor of more than 0.01μF between V
3) Position of opaque board
This product is not designed against irradiation and incorporates non-coherent IRED.
In general, the emission of the IRED used in photocouplers will degrade over time.
In the case of long term operation, please take the general IRED degradation (50% degradation over 5
years) into the design consideration.
Output current
Forward current
Operating terperature
To prevent photointerrupter from faulty operation caused by external light, do not set the detecting face to
the external light.
GND near the device.
Opaque board shall be installed at place 4mm or more from the top of elements.
(Example)
Parameter
Symbol
T
I
I
opr
O
F
MIN.
4mm or more
10
−
0
TYP.
−
−
−
7
MAX.
16
20
70
Unit
mA
mA
˚C
Sheet No.: D3-A03601EN
GP1A51HRJ00F
CC
and