XBP24-DMWIT-250 Digi International, XBP24-DMWIT-250 Datasheet - Page 53

• Manufacturer Part Number: XBP24-DMWIT-250
• Description: XBEE-PRO MESH 2.4 EXTENDED
• Manufacturer: Digi International
• Series: XBEE-PRO™r

Specifications of XBP24-DMWIT-250

• Frequency: 2.4GHz
• Data Rate - Maximum: 250kbps
• Modulation Or Protocol: ISM
• Applications: General Purpose
• Power - Output: 18dBm
• Sensitivity: -100dBm
• Voltage - Supply: 2.8 V ~ 3.4 V
• Current - Receiving: 55mA
• Current - Transmitting: 250mA
• Data Interface: PCB, Through Hole
• Antenna Connector: On-Board, Wire Whip
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: Q4542387

XBee/XBee‐PRO DigiMesh 2.4 RF Modules
Definitions
Appendix A: Definitions
PAN
Network Address
DigiMesh Protocol
Election
Hopping
Node Identifier
Nomination
Route Request
Route Reply
Route Discovery
Sleep coordinator
Sync message
Terms and Definitions
DigiMesh Definitions
© 2010 Digi International, Inc.
Personal Area Network - A data communication network with a
defined set of characteristics that isolates it from other like devices
The 16-bit address is used for compatibility and has an address of
0xFFFE
An election takes place to resolve which node will function as the
network's sleep coordinator if multiple nodes nominate themselves
at the same time
One direct host-to-host connection forming part of the route
between hosts
A string used to identify a node, apart from its address
Nomination is the process whereby a node becomes a sleep coordi-
nator
Broadcast transmission sent by a coordinator or router throughout
the network in attempt to establish a route to a destination node
Unicast transmission sent back to the originator of the route request.
It is initiated by a node when it receives a route request packet and
its address matches the Destination Address in the route request
packet.
The process of establishing a route to a destination node when one
does not exist in the Routing Table. It is based on the AODV (Ad-hoc
On-demand Distance Vector routing) protocol.
Node used to send sync messages in a cyclic sleeping network
A transmission used in a cyclic sleeping network to maintain syn-
chronization
53