XBP24-DMWIT-250 Digi International, XBP24-DMWIT-250 Datasheet - Page 40

• Manufacturer Part Number: XBP24-DMWIT-250
• Description: XBEE-PRO MESH 2.4 EXTENDED
• Manufacturer: Digi International
• Series: XBEE-PRO™r

Specifications of XBP24-DMWIT-250

• Frequency: 2.4GHz
• Data Rate - Maximum: 250kbps
• Modulation Or Protocol: ISM
• Applications: General Purpose
• Power - Output: 18dBm
• Sensitivity: -100dBm
• Voltage - Supply: 2.8 V ~ 3.4 V
• Current - Receiving: 55mA
• Current - Transmitting: 250mA
• Data Interface: PCB, Through Hole
• Antenna Connector: On-Board, Wire Whip
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: Q4542387

XBee/XBee‐PRO DigiMesh 2.4 RF Modules
AT
Command
EE
KY
AT
Command
CH
ID
CE
AT
Command
PL
CA
DB
Encryption and Security
Networking
RF Interfacing
Encryption and Security
Networking
RF Interfacing
Name and Description
Encryption Enable.
Set/Read the encryption enable setting.
Encryption Key.
Set the 128-bit AES encryption key. This command is read-only; KY cannot be read.
Name and Description
Channel.
Set/Read the channel number used for transmitting and receiving data between RF
modules (uses 802.15.4 protocol channel numbers).
Network Identifier.
Set/Read the network identifier for the network. All nodes must have the same network
ID to communicate.
Routing Type. Set/Read the nodes routing type.
Options include:
0 - Router: a node of this type will act as a router in the network.
2 - End Device: a node of this type will not route data for other nodes or relay broadcast
messages.
Name and Description
Power Level.
Set/Read the power level at which the RF module transmits conducted power.
CCA Threshold.
Set/read the CCA (Clear Channel Assessment) threshold. Prior to transmitting a
packet, a CCA is performed to detect energy on the channel. If the detected energy is
above the CCA Threshold, the module will not transmit the packet.
Received Signal Strength.
This command reports the received signal strength of the last received RF data packet.
The DB command only indicates the signal strength of the last hop. It does not provide
an accurate quality measurement for a multihop link. DB can be set to 0 to clear it.
© 2010 Digi International, Inc.
Parameter Range
0 - Encryption Disabled
1 - Encryption Enabled
0-(2
Parameter Range
0x0B - 0x1A (XBee)
0x0C - 0x17 (XBee-PRO)
0 - 0xFFFF
0 - Router
2 - End Device
Parameter Range
XBee
0 = -7dBm
1 = -1.7dBm
2 = -0.77dBm
3 = 0.62dBm
4 = 1.42dBm
XBee-Pro
0 = 10dBm
1 = 12dBm
2 = 14dBm
3 = 16dBm
4 = 18dBm
0x24 - 0x50 [-dBm]
-
128
-1)
Default
0
0
Default
0x0C
0x7FFF
0
Default
4
-
-
40