ATMEGA161-8PI Atmel, ATMEGA161-8PI Datasheet - Page 122

• Manufacturer Part Number: ATMEGA161-8PI
• Description: IC AVR MCU 16K 8MHZ IND 40-DIP
• Manufacturer: Atmel
• Series: AVR® ATmegar

Specifications of ATMEGA161-8PI

• Core Processor: AVR
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: SPI, UART/USART
• Peripherals: POR, PWM, WDT
• Number Of I /o: 35
• Program Memory Size: 16KB (8K x 16)
• Program Memory Type: FLASH
• Eeprom Size: 512 x 8
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 4 V ~ 5.5 V
• Oscillator Type: External
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 40-DIP (0.600", 15.24mm)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Data Converters: -
• Other names: ATMEGA1618PI

Programming the EEPROM
122
ATmega161(L)
The programming algorithm for the EEPROM Data memory is as follows (refer to “Pro-
gramming the Flash” for details on command, address and data loading):
1. A: Load Command “0001 0001”.
2. H: Load Address High Byte ($00 - $01)
3. B: Load Address Low Byte ($00 - $FF)
4. E: Load Data Low Byte ($00 - $FF)
L: Write Data Low Byte
1. Set BS to “0”. This selects low data.
2. Give WR a negative pulse. This starts programming of the data byte. RDY/BSY
3. Wait until to RDY/BSY goes high before programming the next byte.
The loaded command and address are retained in the device during programming. For
efficient programming, the following should be considered:
•
•
•
These considerations also apply to Flash, EEPROM and Signature bytes reading.
Figure 78. Programming the EEPROM Waveforms
RDY/BSY
RESET
PAGEL
XTAL1
DATA
goes low.
(See Figure 78 for signal waveforms.)
The command needs to be loaded only once when writing or reading multiple
memory locations.
Address High byte only needs to be loaded before programming a new 256-word
page in the EEPROM.
Skip writing the data value $FF, that is, the contents of the entire EEPROM after a
Chip Erase.
XA1
XA2
BS1
BS2
WR
OE
+12V
$11
ADDR. HIGH
ADDR. LOW
DATA LOW
1228D–AVR–02/07