M30624FGAFP#U3 Renesas Electronics America, M30624FGAFP#U3 Datasheet - Page 612

• Manufacturer Part Number: M30624FGAFP#U3
• Description: IC M16C MCU FLASH 100QFP
• Manufacturer: Renesas Electronics America
• Series: M16C™ M16C/60r

Specifications of M30624FGAFP#U3

• Core Processor: M16C/60
• Core Size: 16-Bit
• Speed: 16MHz
• Connectivity: SIO, UART/USART
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 85
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 20K x 8
• Voltage - Supply (vcc/vdd): 4.2 V ~ 5.5 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-QFP
• For Use With: 867-1000 - KIT QUICK START RENESAS 62PM3062PT3-CPE-3 - EMULATOR COMPACT M16C/62P/30P
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Appendix 5
1.5 Setup for I/O ports
Figure 1.4.3. VSS pattern on the underside of an oscillator
Figure 1.5.1. Setup for I/O ports
Setup I/O ports using hardware and software as follows:
<Hardware>
<Software>
1.4.3 Oscillator protection using Vss pattern
• As for an input port, read data several times by a program for checking whether input levels are equal or
• As for an output port, since the output data may reverse because of noise, rewrite data to its port latch
• Rewrite data to direction registers and pull-up control registers at fixed periods.
• Connect a resistor of 100
As for a two-sided printed circuit board, print a V
position (on the component side) where an oscillator is mounted.
Connect the V
rate this V
connect the resistor to the microcomputer as close as possible.
not.
at fixed periods.
SS
pattern from other V
SS
Oscillator wiring
pattern example
pattern to the microcomputer V
Oscillator mounting unit
Data bus
or more to a signal line which is connected to an I/O port in series. Besides,
Direction register
Data register
SS
An example of Vss patterns on the
underside of a printed circuit board
patterns.
Top View (on the component side)
SS
X
V
SS
X
pin with the shortest possible wiring. Besides, sepa-
IN
SS
OUT
pattern on the underside (soldering side) of the
I/O port
pin
O.K.
N.G.
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
Noise
Noise
M16C / 62A Group
Mitsubishi microcomputers
2-293