M30624FGAFP#U3 Renesas Electronics America, M30624FGAFP#U3 Datasheet - Page 356

• Manufacturer Part Number: M30624FGAFP#U3
• Description: IC M16C MCU FLASH 100QFP
• Manufacturer: Renesas Electronics America
• Series: M16C™ M16C/60r

Specifications of M30624FGAFP#U3

• Core Processor: M16C/60
• Core Size: 16-Bit
• Speed: 16MHz
• Connectivity: SIO, UART/USART
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 85
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 20K x 8
• Voltage - Supply (vcc/vdd): 4.2 V ~ 5.5 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-QFP
• For Use With: 867-1000 - KIT QUICK START RENESAS 62PM3062PT3-CPE-3 - EMULATOR COMPACT M16C/62P/30P
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Timer A
2.2.16 Precautions for Timer A (pulse width modulation mode)
(1) To clear reset, the count start flag is set to “0”. Set a value in the timer Ai register, then set the
(2) The timer Ai interrupt request bit becomes “1” if setting operation mode of the timer in compli-
(3) Setting the count start flag to “0” while PWM pulses are being output causes the counter to
flag to “1”.
ance with any of the following procedures:
Therefore, to use timer Ai interrupt (interrupt request bit), set timer Ai interrupt request bit to
“0” after the above listed changes have been made.
stop counting. If the TAi
goes to “L”, and the timer Ai interrupt request bit goes to “1”. If the TAi
“L” level in this instance, the level does not change, and the timer Ai interrupt request bit does
not becomes “1”.
• Selecting PWM mode after reset.
• Changing operation mode from timer mode to PWM mode.
• Changing operation mode from event counter mode to PWM mode.
OUT
pin is outputting an “H” level in this instance, the output level
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
OUT
M16C / 62A Group
pin is outputting an
Mitsubishi microcomputers
2-37