101-1121 Rabbit Semiconductor, 101-1121 Datasheet - Page 34

• Manufacturer Part Number: 101-1121
• Description: KIT CAMERA INTERFACE APPLICATION
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 3000r

Specifications of 101-1121

• Sensor Type: Motion, PIR (Pyroelectric Infrared)
• Interface: 10/100 BaseT Ethernet
• Embedded: Yes, Other
• Utilized Ic / Part: RCM3365
• Interface Type: Ethernet
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Voltage - Supply: -
• Sensitivity: -
• Sensing Range: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 316-1119

4.1 RCM3365/RCM3375 Inputs and Outputs
Figure 6 shows the RCM3365/RCM3375 pinouts for headers J3 and J4.
Figure 6. RCM3365/RCM3375 Pinouts
The pinouts for the RCM3000, RCM3100, RCM3200, RCM3300/RCM3310, RCM3360/
RCM3370, and RCM3365/RCM3375 are almost compatible, except signals PB0, PC4, and PC5.
PB0, PC4, and PC5 are used for the SPI interface to the serial flash on the RCM3300 and the
RCM3310, but are available on the other modules. PB0 on the RCM3365 and the RCM3375 is
used to sense whether the removable xD-Picture Card card is installed. If you need PB0 for other
purposes, you may remove the surface-mount resistor at R96 (Figure A-5 shows the location of
R96).
standard 2 × 34 headers with a nominal 2 mm pitch. An RJ-45 Ether-
Headers J3 and J4 are
net port is also included with the RCM3365/RCM3375.
Pins 29–32 on header J3 are configured using 0 Ω resistors at locations JP4, JP5, JP7, and
JP7 to be PD3, PD2, PD7, and PD6 respectively. They may also be reconfigured to carry
the Ethernet signals TPO+, TPO–, TPI+, and TPI–.
Pins 33 and 34 on header J3 are wired to carry the
and
signals that illuminated
LINK
ACT
the corresponding LEDs on the RCM3365/RCM3375 module. These signals may be “dis-
connected” by removing 0 Ω surface-mount resistors R41 and R42
(Figure A-5 shows the
.
locations of R41 and R42)
28
RabbitCore RCM3365/RCM3375