101-1121 Rabbit Semiconductor, 101-1121 Datasheet - Page 144

• Manufacturer Part Number: 101-1121
• Description: KIT CAMERA INTERFACE APPLICATION
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 3000r

Specifications of 101-1121

• Sensor Type: Motion, PIR (Pyroelectric Infrared)
• Interface: 10/100 BaseT Ethernet
• Embedded: Yes, Other
• Utilized Ic / Part: RCM3365
• Interface Type: Ethernet
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Voltage - Supply: -
• Sensitivity: -
• Sensing Range: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 316-1119

E.1 Load TCP/IP Parameters to the RCM3365 Module
1. Connect the 10-pin
2. Use the
This sample program brings down the Ethernet interface, turns off DHCP, sets the
RCM3365's IP address to 10.10.6.100, sets the netmask to 255.255.255.0, and sets the
default gateway to 10.10.6.1.
The IP and gateway addresses can be changed in the two macros in the two macros at the
beginning of the sample program:
To restore the RCM3365 to its default DHCP behavior, uncomment the
macro:
138
the RCM3365 module as described in Section 2.2.2. (Do not use the
the Dynamic C
run the program.
#define _IPADDR"10.10.6.100"
#define _GATEWAY"10.10.6.1"
//#define ENABLE_DHCP
File
menu to open the sample program
SAMPLES\RABBITSYS
PROG
The RCM3365 module is now set up.
connector of the serial programming cable to header J1 on
folder. Press function key
SETUPFORCROSSOVER.C
RabbitCore RCM3365/RCM3375
F9
DIAG
ENABLE_DHCP
to compile and
, which is in
connector.)