CDB5571 Cirrus Logic Inc, CDB5571 Datasheet - Page 15

• Manufacturer Part Number: CDB5571
• Description: DEV BOARD FOR CS5571 W/MUX
• Manufacturer: Cirrus Logic Inc
• Type: A/Dr

Specifications of CDB5571

• Number Of Adc's: 1
• Number Of Bits: 16
• Sampling Rate (per Second): 100k
• Data Interface: Serial
• Inputs Per Adc: 2 Single
• Input Range: 2.4 ~ 4.2 V
• Voltage Supply Source: Dual ±
• Operating Temperature: -40°C ~ 85°C
• Utilized Ic / Part: CS5571
• Product: Data Conversion Development Tools
• Conversion Rate: 100 KSPS
• Resolution: 16 bit
• Maximum Clock Frequency: 16 MHz
• Interface Type: SPI
• Supply Voltage (max): 3.3 V
• Supply Voltage (min): - 2.5 V
• For Use With/related Products: CS5571
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant
• Other names: 598-1275; CDB5571-1

3.3 Voltage Reference
The voltage reference for the CS5571 can range from 2.4 volt to 4.2 volts. A 4.096 volt reference is re-
quired to achieve the specified signal-to-noise performance.
tion of the voltage reference with either a single +5 V analog supply or with ±2.5 V.
For optimum performance, the voltage reference device should be one that provides a capacitor connec-
tion to provide a means of noise filtering, or the output should include some type of bandwidth-limiting fil-
ter.
Some 4.096 volt reference devices need only 5 volts total supply for operation and can be connected as
shown in
output capacitor.
Some older 4.096 voltage reference designs require more headroom and must operate from an input volt-
age of 5.5 to 6.5 volts. If this type of voltage reference is used ensure that when power is applied to the
system, the voltage reference rise time is slower than the rise time of the V1+ and V1- power supply volt-
age to the converter. An example circuit to slow the output startup time of the reference is illustrated in
Figure
3.4 Analog Input
The analog input of the converter is single-ended with a full-scale input of
ACOM pin.. This is illustrated in
amplifier configuration for driving the CS5571.
The capacitors at the outputs of the amplifiers provide a charge reservoir for the dynamic current from the
A/D inputs while the resistors isolate the dynamic current from the amplifier. The amplifiers can be pow-
ered from higher supplies than those used by the A/D but precautions should be taken to ensure that the
op-amp output voltage remains within the power supply limits of the A/D, especially under start-up condi-
tions.
DS768PP1
5.
Figure 6
or
Figure
5.5 to 15 V
7. The reference should have a local bypass capacitor and an appropriate
10µF
2k
Figure 6
Figure 5. Voltage Reference Circuit
GND
VIN
and
VOUT
Figure
3/25/08
10:56
7. These diagrams also illustrate a differential buffer
4.096 V
Refer to V1- and VREF1 pins.
Figure 6
and
Figure 7
±
2.048 volts, relative to the
illustrate the connec-
CS5571
15