EPM2210F100A ALTERA [Altera Corporation], EPM2210F100A Datasheet - Page 35

• Manufacturer Part Number: EPM2210F100A
• Description: MAX II Device Family
• Manufacturer: ALTERA [Altera Corporation]

Chapter 2: MAX II Architecture
I/O Structure
Figure 2–22. MAX II I/O Banks for EPM240 and EPM570
Notes to
(1)
(2)
© October 2008 Altera Corporation
Figure 2–22
Figure 2–22
Figure
2–22:
is a top view of the silicon die.
is a graphical representation only. Refer to the pin list and the Quartus II software for exact pin locations.
I/O Bank 1
Table 2–4
Table 2–4. MAX II I/O Standards
The EPM240 and EPM570 devices support two I/O banks, as shown in
Each of these banks support all the LVTTL and LVCMOS standards shown in
Table
The EPM1270 and EPM2210 devices support four I/O banks, as shown in
Each of these banks support all of the LVTTL and LVCMOS standards shown in
Table
clamping diode on inputs and PCI drive compliance on outputs. You must use Bank 3
for designs requiring PCI compliant I/O pins. The Quartus II software automatically
places I/O pins in this bank if assigned with the PCI I/O standard.
3.3-V LVTTL/LVCMOS
2.5-V LVTTL/LVCMOS
1.8-V LVTTL/LVCMOS
1.5-V LVCMOS
3.3-V PCI
Note to
(1) The 3.3-V PCI compliant I/O is supported in Bank 3 of the EPM1270 and EPM2210
devices.
I/O Standard
2–4. PCI compliant I/O is not supported in these devices and banks.
2–4. PCI compliant I/O is supported in Bank 3. Bank 3 supports the PCI
Table
(1)
describes the I/O standards supported by MAX II devices.
2–4:
All I/O Banks Support
■
■
■
■
3.3-V LVTTL/LVCMOS
2.5-V LVTTL/LVCMOS
1.8-V LVTTL/LVCMOS
1.5-V LVCMOS
Single-ended
Single-ended
Single-ended
Single-ended
Single-ended
(Note
Type
1),
(2)
Output Supply Voltage
(VCCIO) (V)
3.3
2.5
1.8
1.5
3.3
I/O Bank 2
MAX II Device Handbook
Figure
Figure
2–22.
2–23.
2–27