AD7192BRUZ Analog Devices Inc, AD7192BRUZ Datasheet - Page 30

• Manufacturer Part Number: AD7192BRUZ
• Description: IC ADC 24BIT 2CH W/PGA 24-TSSOP
• Manufacturer: Analog Devices Inc

Specifications of AD7192BRUZ

• Data Interface: DSP, MICROWIRE™, QSPI™, Serial, SPI™
• Design Resources: Precision Weigh Scale Design Using AD7192 with Internal PGA (CN0119)
• Number Of Bits: 24
• Sampling Rate (per Second): 4.8k
• Number Of Converters: 1
• Voltage Supply Source: Analog and Digital
• Operating Temperature: -40°C ~ 105°C
• Mounting Type: Surface Mount
• Package / Case: 24-TSSOP (0.173", 4.40mm Width)
• Resolution (bits): 24bit
• Input Channel Type: Pseudo Differential
• Supply Voltage Range - Analogue: 3V To 5.25V
• Supply Voltage Range - Digital: 2.7V To 5.25V
• Supply: RoHS Compliant
• Sampling Rate: 4.8kSPS
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AD7192
Continuous Conversion Mode
Continuous conversion is the default power-up mode. The
AD7192 converts continuously, and the RDY bit in the status
register goes low each time a conversion is complete. If CS is
low, the DOUT/ RDY line also goes low when a conversion is
completed. To read a conversion, the user writes to the
communications register, indicating that the next operation is a
read of the data register. When the data-word has been read
from the data register, DOUT/ RDY goes high. The user can
read this register additional times, if required. However, the
user must ensure that the data register is not being accessed at
the completion of the next conversion or else the new conversion
word is lost.
DOUT/RDY
SCLK
DIN
CS
0x58
Figure 30. Continuous Conversion
Rev. A | Page 30 of 40
DATA
When several channels are enabled, the ADC continuously
loops through the enabled channels, performing one conversion
on each channel per loop. The data register is updated as soon
as each conversion is available. The DOUT/ RDY pin pulses low
each time a conversion is available. The user can then read the
conversion while the ADC converts on the next enabled channel.
If the DAT_STA bit in the mode register is set to 1, the contents
of the status register are output along with the conversion each
time that the data read is performed. The status register
indicates the channel to which the conversion corresponds.
0x58
DATA