CP3BT10G38 National Semiconductor, CP3BT10G38 Datasheet - Page 148

• Manufacturer Part Number: CP3BT10G38
• Description: IC CPU RISC W/LLC&USB 100-LQFP
• Manufacturer: National Semiconductor

Specifications of CP3BT10G38

• Applications: Connectivity Processor
• Core Processor: CR16C
• Program Memory Type: FLASH (256 kB)
• Controller Series: CP3000
• Ram Size: 10K x 8
• Interface: Bluetooth, ACCESS.bus, Audio, UART, USB, Microwire/SPI
• Number Of I /o: 37
• Voltage - Supply: 2.25 V ~ 2.75 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 100-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: *CP3BT10G38

www.national.com
23.3
Each Multi-Function Timer unit has four interrupt sources,
designated A, B, C, and D. Interrupt sources A, B, and C are
mapped into a single system interrupt called Timer Interrupt
1, while interrupt source D is mapped into a system interrupt
called Timer Interrupt 2. Each of the four interrupt sources
has its own enable bit and pending bit. The enable bits are
named TAIEN, TBIEN, TCIEN, and TDIEN. The pending
bits are named TAPND, TBPND, TCPND, and TDPND.
Timer Interrupts 1 and 2 are system interrupts TA and TB
(IRQ14 and IRQ13), respectively.
Table 51 shows the events that trigger interrupts A, B, C,
and D in each of the four operating modes. Note that some
interrupt sources are not used in some operating modes.
Timer
Int. 1
(TA Int.)
Timer
Int. 2
(TB Int.)
TA
Sys. Int.
I/O
TIMER INTERRUPTS
TAEN = 0
TBEN = X
TAEN = 1
TBEN = X
TAPND
TBPND
TCPND
TDPND
Interrupt
Pending
TBEN
TAEN
Bit
TCNT1 reload from TCRA Input capture on TA transition TCNT1 reload from TCRA
TCNT1 reload from TCRB Input Capture on TB
N/A
TCNT2 underflow
No Output
Toggle Output on
Underflow of TCNT1
PWM + Counter
PWM + Counter
Table 51 Timer Interrupts Overview
Mode 1
Mode 1
Table 52 Timer I/O Functions
148
transition
TCNT1 underflow
TCNT2 underflow
Capture TCNT1 into TCRA
Capture TCNT1 into TCRA
and Preset TCNT1
23.4
Table 52 shows the functions of the TA pin in each operating
mode, and for each combination of enable bit settings.
When the TA pin is configured to operate as a PWM output
(TAEN = 1), the state of the pin is toggled on each underflow
of the TCNT1 counter. In this case, the initial value on the
pin is determined by the TAOUT bit. For example, to start
with TA high, software must set the TAOUT bit before en-
abling the timer clock. This option is available only when the
timer is configured to operate in Mode 1 or 3 (in other words,
when TCRA is not used in Capture mode).
Dual Input Capture +
Dual Input Capture +
Counter
counter
Mode 2
Mode 2
TIMER I/O FUNCTIONS
N/A
N/A
TCNT2 reload from TCRB
No Output Toggle
Toggle Output on Underflow
of TCNT1
Dual Counter
Dual Counter
Mode 3
Mode 3