FS2003-UPG7 Equinox Technologies, FS2003-UPG7 Datasheet - Page 75

• Manufacturer Part Number: FS2003-UPG7
• Description: UPGRADE FS2003 JTAG ISP AVR MCU
• Manufacturer: Equinox Technologies
• Type: Upgrade Kitr

Specifications of FS2003-UPG7

• Mfg Application Notes: SPI and JTAG (ISP), Appl Note
• For Use With/related Products: FS2003
• Other names: 483-1009

5
6
7
8
9
10
Key
O - Output from programmer to Target Device
I - Input to programmer from Target Device
P - Passive eg. GROUND and power rails
N/C - Not connected
72
PROG_RESET O
PROG_GND
PROG_SCK1
PROG_GND
PROG_MISO
PROG_GND
P
O
P
I
P
RESET
GROUND
SCK
GROUND
MISO
(except for
ATmega103/128/64
– connect to TXD
pin instead)
GROUND
FS2003 ISP Programmer - User Guide V1.08 – 1
Target RESET control pin
This pin controls the Target Device
RESET pin. It will be driven HIGH/LOW
according to the device type and settings
in the ‘Pre-program State Machine’ tab in
the Eqtools project.
Ground Connection
Common ground connection between the
programmer and Target System.
SPI Serial Clock Output
This is the SPI clock output signal.
Ground Connection
Common ground connection between the
programmer and Target System.
Master In Slave Out
This is the SPI data input pin to the
programmer. This pin should be
connected to the MISO pin on the Target
Microcontroller.
Ground Connection
Common ground connection between
PROGRAMMER and Target System.
st
August 2008