PG-FP4-E Renesas Electronics America, PG-FP4-E Datasheet - Page 80

• Manufacturer Part Number: PG-FP4-E
• Description: PROGRAMMER FLASH MEMORY UNIV
• Manufacturer: Renesas Electronics America

Specifications of PG-FP4-E

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

78
8.
Terminating system
<1> If it is not necessary to program other devices, select [File] → [Quit] and terminate the GUI software.
<2> Remove the FA adaptor (target system) from the target cable.
<3> Turn off the switch of the power supply unit.
<4> Remove the power supply unit and either the RS-232C cable or USB cable from PG-FP4.
Caution If the “E501 Operation failed” error occurs, check the following points.
• Check the wiring of the pins used for writing the target device on the target board and the processing of the
• Check if the following set values match the actual writing environment, by selecting the [Device] → [Setup…]
• Check to see if the CPU clock and communication clock are within the range of the specifications of the
• When UART is used, communication may not be synchronized due to a baud rate error of the target device.
other pins, by referring to the user’s manual of the target device.
menu.
Clock supply source
V
Communication mode to be used
Parameter file, etc.
target device.
In this case, change the CPU clock or baud rate, or change the communication mode to SIO.
DD
All the settings made so far have been saved, so that they can be reused when the GUI software is
restarted (all the settings are also saved to the internal EEPROM of the PG-FP4).
supply source
CHAPTER 5 SAMPLE PROGRAMMING SESSION USING GUI SOFTWARE
User’s Manual U15260EJ4V0UM