PG-FP4-E Renesas Electronics America, PG-FP4-E Datasheet - Page 59

• Manufacturer Part Number: PG-FP4-E
• Description: PROGRAMMER FLASH MEMORY UNIV
• Manufacturer: Renesas Electronics America

Specifications of PG-FP4-E

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

<2> Communication interface to device
Item on Screen
“Communication interface to device” selects the channel for communication between the PG-FP4 and target
device. For the communication port and communication rate that can be selected, refer to the user’s manual
of the device used.
[Port list box]
Select the mode of communication between the PG-FP4 and target device from the following.
The communication mode is determined by the number of V
The selectable communication mode differs depending on the target device. Refer to the user’s manual of the
target device used and select a mode. With some devices, the number starts from ch1. In this case, ch0 of
the parameter on the screen equals ch1 of the device, and the displayed channel number must be shifted
accordingly.
Note When using a single-power-supply flash memory microcontroller.
UART-ch0
UART-ch1
UART-ch2
UART-ch3
SIO-H/S
Port-ch0
Port-ch1
Port-ch2
SIO-ch0
SIO-ch1
SIO-ch2
IIC-ch0
IIC-ch1
IIC-ch2
IIC-ch3
Figure 4-25. Setup Window – Communication Interface to Device
SIO (3-wire clocked communication port) channel 0
SIO (3-wire clocked communication port) channel 1
SIO (3-wire clocked communication port) channel 2
SIO (3-wire clocked communication port, with handshake)
I
I
I
I
UART (asynchronous communication port) channel 0
UART (asynchronous communication port) channel 1
UART (asynchronous communication port) channel 2
UART (asynchronous communication port) channel 3
Port (pseudo 3-wire) A
Port (pseudo 3-wire) B
Port (pseudo 3-wire) C
2
2
2
2
C channel 0
C channel 1
C channel 2
C channel 3
CHAPTER 4 PG-FP4 OPERATION USING GUI SOFTWARE
User’s Manual U15260EJ4V0UM
Description
PP
or FLMD0
Note
pulses output by the PG-FP4.
57