ST7MDT20-DVP3 STMicroelectronics, ST7MDT20-DVP3 Datasheet - Page 32

• Manufacturer Part Number: ST7MDT20-DVP3
• Description: KIT EMULATOR FOR ST72321/324/521
• Manufacturer: STMicroelectronics
• Series: ST7-DVP3r
• Type: Microcontrollerr

Specifications of ST7MDT20-DVP3

• Contents: Main Emulation Board (MEB), Target Emulation Board (TEB), Cables, Power Supply and Documentation
• For Use With/related Products: ST72321, ST72324, ST72521
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-4874

Appendix C: Troubleshooting
APPENDIX C:TROUBLESHOOTING
C.1
32/44
Identifying the problem
IF...
You receive the Error Message
(when starting the STVD7 for
DVP):
“Connection Error (LPT1):
Interconnection failure. Ver-
ify your input/output cable.”
You receive the Error Message
(during STVD7 session):
“Emulator power off has been
detected.”
THEN...
Ensure that:
•
•
•
•
If none of the above items has been overlooked, this may
mean that your parallel port connection needs to be
reconfigured.
Please refer to
set up
Ensure that your emulator is powered on and shutdown
and restart your STVD7 session.
The parallel cable is connected directly between the
emulator and one of the PC’s parallel ports (LPT1 or
LPT2). Note that the use of switch boxes between the
parallel port connector of your PC and the emulator is
not recommended.
The emulator is powered on.
The parallel cable used is the one supplied with the kit
by STMicroelectronics.
STVD7 and Windows Epromer are not running at the
same time. If this is the case then shut down both and
ensure that only one or the other is running at any one
time.
on page 13.
Section 3.1.2: Changing the parallel port
ST7-DVP3 Emulator User Manual