ST7MDT20-DVP3 STMicroelectronics, ST7MDT20-DVP3 Datasheet - Page 11

• Manufacturer Part Number: ST7MDT20-DVP3
• Description: KIT EMULATOR FOR ST72321/324/521
• Manufacturer: STMicroelectronics
• Series: ST7-DVP3r
• Type: Microcontrollerr

Specifications of ST7MDT20-DVP3

• Contents: Main Emulation Board (MEB), Target Emulation Board (TEB), Cables, Power Supply and Documentation
• For Use With/related Products: ST72321, ST72324, ST72521
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-4874

STEP 3: To connect to the target MCU, plug
the ICC cable into the ICC connector on the
ST7-DVP3 emulator and the HE10 connector
on your application board.
STEP 4: Connect the ferrite clip to the power
supply cord between the supply and your
ST7-DVP3 emulator.
STEP 5: Connect the power supply to your
emulator. For power supply information,
refer to
page 17.
ST7-DVP3 Emulator User Manual
2.3
STEP 1: Connect your emulator to your host PC via parallel or USB port, as shown in
Figure 3
Warning: Never have an application running when you set the operating voltage. Setting it to 3.3V
STEP 2: Switch the ST7-DVP3 emulator to the selected operating voltage, either 3.3V or 5V,
as shown in
Note:
Warning: Never power on your application board while your emulator is powered off—this can
STEP 6: Power up your ST7-DVP3 emulator.
STEP 7: Power up your application.
!
!
. For more details about PC connection, refer to
Section 4.3.2: Power supply
Quick set up for ICC configuration
while an application is running at 5V can seriously damage the emulator.
In order to use the ICC connection, you must design your application board with an HE10
connector linked to your target microcontroller. The pins connected to the HE10 connector
must use a signal voltage of 3.3 or 5 V. For more information refer to
connection
seriously damage your emulator. When powering up, always turn on your emulator
first. When powering off, always power off your application first.
Figure 3
.
on page 24.
on
Figure 5: Connect your application
Power supply cable
Chapter 3: Connectivity
HE10 connector on
application board
Getting Started with ST7-DVP3
ICC cable
adapter (not used)
Flat cables and
Section 5.2: ICC
ST7
on page 12.
11/44