C8051F300-TB Silicon Laboratories Inc, C8051F300-TB Datasheet - Page 115

• Manufacturer Part Number: C8051F300-TB
• Description: BOARD PROTOTYPING W/C8051F300
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051F300-TB

• Contents: Board
• Data Bus Width: 8 bit
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: C8051F300
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

13.4. Using the SMBus
The SMBus can operate in both Master and Slave modes. The interface provides timing and shifting con-
trol for serial transfers; higher level protocol is determined by user software. The SMBus interface provides
the following application-independent features:
•
•
•
•
•
•
•
SMBus interrupts are generated for each data byte or slave address that is transferred. When transmitting,
this interrupt is generated after the ACK cycle so that software may read the received ACK value; when
receiving data, this interrupt is generated before the ACK cycle so that software may define the outgoing
ACK value. See
sequences.
Interrupts are also generated to indicate the beginning of a transfer when a master (START generated), or
the end of a transfer when a slave (STOP detected). Software should read the SMB0CN (SMBus Control
register) to find the cause of the SMBus interrupt. The SMB0CN register is described in
“13.4.2. SMB0CN Control Register” on page
ence.
SMBus configuration options include:
•
•
•
•
These options are selected in the SMB0CF register, as described in
tion Register” on page
Byte-wise serial data transfers
Clock signal generation on SCL (Master Mode only) and SDA data synchronization
Timeout/bus error recognition, as defined by the SMB0CF configuration register
START/STOP timing, detection, and generation
Bus arbitration
Interrupt generation
Status information
Timeout detection (SCL Low Timeout and/or Bus Free Timeout)
SDA setup and hold time extensions
Slave event enable/disable
Clock source selection
Section “13.5. SMBus Transfer Modes” on page 123
116.
119; Table 13.4 provides a quick SMB0CN decoding refer-
Rev. 2.9
C8051F300/1/2/3/4/5
Section “13.4.1. SMBus Configura-
for more details on transmission
Section
115