STEVAL-MKI062V2 STMicroelectronics, STEVAL-MKI062V2 Datasheet - Page 4

• Manufacturer Part Number: STEVAL-MKI062V2
• Description: BOARD EVAL FOR MEMS SENSORS
• Manufacturer: STMicroelectronics
• Series: iNEMOr

Specifications of STEVAL-MKI062V2

• Design Resources: STEVAL-MKI062V2 Gerber Files STEVAL-MKI062V2 Schematic STEVAL-MKI062V2 Bill of Materials
• Sensor Type: Accelerometer, Gyroscope, Magnetometer, Pressure, Temperature
• Sensing Range: ±2g,4g,8g; 300 ~ 1100mbar; 300°/sec; -55 ~125°C
• Interface: I²C, USB
• Sensitivity: Multiple
• Voltage - Supply: 5V, USB
• Embedded: Yes, MCU, 32-Bit
• Utilized Ic / Part: LPR430AL, LY330ALH, LSM303DLH, LPS001DL, STM32F103RE, STLM75
• Interface Type: USB, CAN, I2C
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 55 C
• Silicon Manufacturer: STMicroelectronics
• Kit Application Type: Sensor
• Application Sub Type: MEMS Device
• Silicon Family Name: INEMO
• Kit Contents: MicroSD Card Slot, COM Connector, Reset Button,
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: STM32F103RE
• Other names: 497-10508

iNEMO V2 GUI installation
1
1.1
1.2
Note:
1.3
Note:
4/18
iNEMO V2 GUI installation
The installation of the graphical user interface (GUI) requires the following two steps:
1.
2.
PC system requirement
●
●
PC software installation
To install the iNEMO suite, run the setup file and follow the instructions.
The latest setup file is available on st.com.
Virtual Com driver installation
To install the virtual COM driver, plug the iNEMO board into a free USB port, an icon should
appear in the “Notify Bar”, as in
and follow the instructions in
Figure 2.
If, after a few seconds, the “Hardware Update Wizard” doesn`t appear, follow the
instructions given in
Install the PC software delivered with the demonstration kit
Install the virtual COM driver needed to use the board
Microsoft Windows XP
Microsoft.NET Framework 2.0 (or higher)
STEVAL-MKI062V2 notification icon
Figure 3
®
Figure
Service Pack 2, or higher
and then in 4.
Doc ID 18054 Rev 1
Figure
4.
2. Wait for the “Hardware Update Wizard” window
UM1010