EVAL-AD5379EBZ Analog Devices Inc, EVAL-AD5379EBZ Datasheet - Page 14

• Manufacturer Part Number: EVAL-AD5379EBZ
• Description: BOARD EVALUATION FOR AD5379
• Manufacturer: Analog Devices Inc

Specifications of EVAL-AD5379EBZ

• Number Of Dac's: 40
• Number Of Bits: 14
• Outputs And Type: 40, Single Ended
• Sampling Rate (per Second): 50k
• Data Interface: Serial, Parallel
• Settling Time: 20µs
• Dac Type: Voltage
• Voltage Supply Source: Analog and Digital, Dual ±
• Operating Temperature: -40°C ~ 85°C
• Utilized Ic / Part: AD5379
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AD5379
Pin
FIFOEN
RESET
REFGNDA1
REFGNDA2
REFGNDB1
REFGNDB2
REFGNDC1
REFGNDC2
REFGNDD1
REFGNDD2
1
These serial interface signals do not require separate pins, but share parallel interface pins.
Function
FIFO Enable (Level Sensitive, Active High). When connected to DVDD, the internal FIFO is enabled, allowing the user to
write to the device at full speed. FIFO is available in both serial and parallel mode. The FIFOEN pin has an internal
1 MΩ pull-down resistor connected to ground, meaning that the FIFO is disabled by default.
Asynchronous Digital Reset Input (Falling Edge Sensitive). If unused, RESET may be left unconnected; an internal pull-
up resistor (1 MΩ) ensures that the RESET input is held high. The function of this pin is equivalent to that of the power-
on reset generator. When this pin is taken low, the AD5379 state machine initiates a reset sequence to digitally reset
x1, m, c, and x2 registers to their default power-on values. This sequence takes 100 μs (typ). Furthermore, the input to
each of the DAC output buffer stages, VOUT0 to VOUT39, is switched to the externally set potential on the relevant
REFGND pin. During RESET , BUSY goes low and the parallel interface is disabled. All LDAC pulses are ignored until
BUSY goes high. When RESET is taken high again, the DAC ouputs remain at REFGND until LDAC is taken low.
Reference Ground for DACs 0 to 7. VOUT0 to VOUT7 are referenced to this voltage.
Reference Ground for DACs 8 and 9. VOUT8 and VOUT9 are referenced to this voltage.
Reference Ground for DACs 10 to 17. VOUT10 to VOUT17 are referenced to this voltage.
Reference Ground for DACs 18 and 19. VOUT18 and VOUT19 are referenced to this voltage.
Reference Ground for DACs 20 to 27. VOUT20 to VOUT27 are referenced to this voltage.
Reference Ground for DACs 28 and 29. VOUT28 and VOUT29 are referenced to this voltage.
Reference Ground for DACs 30 to 37. VOUT30 to VOUT37 are referenced to this voltage.
Reference Ground for DACs 38 and 39. VOUT38 and VOUT39 are referenced to this voltage.
Rev. B | Page 14 of 28