LPC1114FHN33/302 NXP Semiconductors, LPC1114FHN33/302 Datasheet - Page 41

• Manufacturer Part Number: LPC1114FHN33/302
• Description: ARM Microcontrollers - MCU 32b 32K Flash 42I/O
• Manufacturer: NXP Semiconductors

Specifications of LPC1114FHN33/302

• Rohs: yes
• Core: ARM Cortex M0
• Processor Series: LPC1114
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 32 KB
• Data Ram Size: 8 KB
• Package / Case: HVQFN-33
• Mounting Style: SMD/SMT
• Interface Type: I2C, SPI, SSP, UART
• Maximum Operating Temperature: + 85 C
• Number Of Programmable I/os: 42
• Number Of Timers: 4
• Program Memory Type: Flash
• Factory Pack Quantity: 260
• Tradename: LPC1100L

NXP Semiconductors
Table 11.
[1]
[2]
[3]
[4]
[5]
[6]
LPC111X
Product data sheet
Symbol
V
XTALIN
XTALOUT
V
DD
SS
Pin state at reset for default function: I = Input; O = Output; PU = internal pull-up enabled (pins pulled up to full V
IA = inactive, no pull-up/down enabled.
See
reset the chip and wake up from Deep power-down mode. An external pull-up resistor is required on this pin for the Deep power-down
mode.
5 V tolerant pad providing digital I/O functions with configurable pull-up/pull-down resistors and configurable hysteresis (see
I
5 V tolerant pad providing digital I/O functions with configurable pull-up/pull-down resistors, configurable hysteresis, and analog input.
When configured as a ADC input, digital section of the pad is disabled, and the pin is not 5 V tolerant (see
When the system oscillator is not used, connect XTALIN and XTALOUT as follows: XTALIN can be left floating or can be grounded
(grounding is preferred to reduce susceptibility to noise). XTALOUT should be left floating.
2
C-bus pads compliant with the I
Figure 48
LPC1100XL series: LPC1111/12/13/14 pin description table (HVQFN33 package)
for the reset pad configuration. RESET functionality is not available in Deep power-down mode. Use the WAKEUP pin to
Pin
6; 29 -
4
5
33
[6]
[6]
Start
logic
input
-
-
-
2
C-bus specification for I
Type Reset
I
I
O
-
All information provided in this document is subject to legal disclaimers.
state
[1]
-
-
-
-
Rev. 8 — 20 February 2013
Description
3.3 V supply voltage to the internal regulator, the external rail, and the
ADC. Also used as the ADC reference voltage.
Input to the oscillator circuit and internal clock generator circuits. Input
voltage must not exceed 1.8 V.
Output from the oscillator amplifier.
Thermal pad. Connect to ground.
2
C standard mode and I
LPC1110/11/12/13/14/15
2
C Fast-mode Plus.
32-bit ARM Cortex-M0 microcontroller
…continued
Figure
DD
© NXP B.V. 2013. All rights reserved.
47).
level (V
DD
Figure
= 3.3 V));
41 of 114
47).