2726188 Phoenix Contact, 2726188 Datasheet - Page 140

• Manufacturer Part Number: 2726188
• Description: INTERBUS Bus Coupler
• Manufacturer: Phoenix Contact

IL SYS INST UM E
10-20
PHOENIX CONTACT
Connect the brake as shown in Figure 10-19:
•
•
•
•
•
•
Figure 10-19
10.5.4
Hand-held operator panel mode (manual mode) is enabled via a temporarily connected
external hand-held operator panel. This panel is connected to the power-level terminal
using a 4-pos. MINI-COMBICON connector. The slot is under the upper release flap
(6 in Figure 10-9 on page 10-14). The hand-held operator panel can only be connected
when the release flap is upright.
A
For additional information about the brake module, please refer to the module-specific
data sheet.
For the ordering data for the hand-held operator panel, please refer to the
Phoenix Contact "AUTOMATION" catalog.
For additional information about hand-held operator panel mode, please refer to the data
sheets for the power-level terminals.
If the motor connector is plugged in, remove it. The entire module should be prepared
(power-level terminal with brake module) before the I/O is connected.
Lift up the lower release flap (detail A1).
Snap the brake module into connection X8 (detail A2). Fasten the brake module by
turning the interlocking screw (1) 90°. This secures the interlocking screw in a
ventilation slot of the power-level terminal.
Put the lower release flap down again (detail B1).
Insert the assembled motor circuit connector into connection X10 (detail B2). (See also
"Connecting the motor circuit connector" on page 10-17.)
Insert the assembled connector for the brake into connection X9 of the brake module
(detail B3).
Connecting the hand-held operator panel
Snapping on the brake module and the connector for the brake
A2
A1
1
B
B2
B1
B3
6452_en_02
5