AT32UC3A0512-ALTES ATMEL [ATMEL Corporation], AT32UC3A0512-ALTES Datasheet - Page 74

• Manufacturer Part Number: AT32UC3A0512-ALTES
• Description: AVR32 32-Bit Microcontroller
• Manufacturer: ATMEL [ATMEL Corporation]

15.4.2
15.4.3
32058FS–AVR32–08/08
PWM
SSC
1. PWM counter restarts at 0x0001
2. PWM channel interrupt enabling triggers an interrupt
3. PWM update period to a 0 value does not work
4.
1. SSC does not trigger RF when data is low
2. SSC Data is not sent unless clock is set as output
Fix/workaround
When multiple CS are in use, if one of the baudrate equals 1, the other must also equal 1 if
CPOL=1 and CPHA=0.
The PWM counter restarts at 0x0001 and not 0x0000 as specified. Because of this the first
PWM period has one more clock cycle.
Fix/Workaround
- The first period is 0x0000, 0x0001, ..., period
- Consecutive periods are 0x0001, 0x0002, ..., period
When enabling a PWM channel that is configured with center aligned period (CALG=1), an
interrupt is signalled.
Fix/Workaround
When using center aligned mode, enable the channel and read the status before channel
interrupt is enabled.
It is impossible to update a period equal to 0 by the using the PWM update register
(PWM_CUPD).
Fix/Workaround
Do not update the PWM_CUPD register with a value equal to 0.
Before a PWM period has elapsed, the read channel status may be wrong. The CHIDx-bit
for a PWM channel in the PWM Enable Register will read '1' for one full PWM period even if
the channel was disabled before the period elapsed. It will then read '0' as expected.
Fix/Workaround
Reading the PWM channel status of a disabled channel is only correct after a PWM period
has elapsed.
The SSC cannot transmit or receive data when CKS = CKDIV and CKO = none, in TCMR or
RCMR respectively.
Fix/Workaround
Set CKO to a value that is not "none" and bypass the output of the TK/RK pin with the PIO.
The SSC cannot transmit or receive data when CKS = CKDIV and CKO = none, in TCMR or
RCMR respectively.
Fix/Workaround
Set CKO to a value that is not "none" and bypass the output of the TK/RK pin with the PIO.
PWM channel status may be wrong if disabled before a period has elapsed
AT32UC3A
74