AT90USB1286-16MU ATMEL [ATMEL Corporation], AT90USB1286-16MU Datasheet - Page 258
![no-image](/images/no-image-200.jpg)
AT90USB1286-16MU
Manufacturer Part Number
AT90USB1286-16MU
Description
Microcontroller with 64/128K Bytes of ISP Flash and USB Controller
Manufacturer
ATMEL [ATMEL Corporation]
Datasheet
1.AT90USB1286-16MU.pdf
(434 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
- Current page: 258 of 434
- Download datasheet (4Mb)
21.6.2
21.7
21.8
258
Memory access capability
Memory management
AT90USB64/128
Host mode
When the USB interface is configured in device mode, internal Pull Down resistors are activated
on both UDP UDM lines and the interface detects the type of device connected.
The CPU has the possibility to directly access to the USB internal memory (DPRAM).
The memory access mode is performed using 2 sfr’s: UDPADDH and UDPADDL.
To enter in this mode:
Even if the USBE bit is cleared, the DPACC bit and DPADD10:0 field can be used by the
firmware.
Then, a read or a write in UEDATX (device mode) or in UPDATX (host mode) is performed
according to DPADD10:0 and the base address DPADD10:0 field is automatically increased.
The endpoint FIFO pointers and the value of the UxNUM registers are discarded in this mode.
The aim of this functionality is to use the DPRAM as extra-memory.
When using this mode, there is no influence over the USB controller.
The controller does only support the following memory allocation management:
The reservation of a Pipe or an Endpoint can only be made in the growing order (Pipe/Endpoint
0 to the last Pipe/Endpoint). The firmware shall thus configure them in the same order.
The reservation of a Pipe or an Endpoint “k
ware allocates the memory and insert it between the Pipe/Endpoints “k
Pipe/Endpoint memory “slides” up and its data is lost. Note that the “k
point memory does not slide.
Clearing a Pipe enable (PEN) or an Endpoint enable (EPEN) does not clear neither its ALLOC
bit, nor its configuration (EPSIZE/PSIZE, EPBK/PBK). To free its memory, the firmware should
• the USBE bit must be cleared.
• the DPACC bit and the base address DPADD10:0 must be set.
Endpoint 1 to N
USB DPRAM
Endpoint 0
Unused
i
” is done when its ALLOC bit is set. Then, the hard-
[DPADDH - DPADDL]
i+2
i-1
” and upper Pipe/End-
” and “k
i+1
7593A–AVR–02/06
”. The “k
i+1
”
Related parts for AT90USB1286-16MU
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![AT90USBKEY](/photos/15/94/159427/at90usbkey_tmb.jpg)
Part Number:
Description:
MCU, MPU & DSP Development Tools Demo board f/AVR MCU & AT90USB
Manufacturer:
Atmel
Datasheet:
![AT88SC0204CA-SH](/images/no-image3.png)
Part Number:
Description:
Atmel CryptoMemory
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
![AT88SC0808CA-SH](/images/no-image3.png)
Part Number:
Description:
Atmel CryptoMemory
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
![AT88SC1616C-SH](/images/no-image3.png)
Part Number:
Description:
Atmel CryptoMemory, 16Kbit
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
![AT25DF161-SH](/images/no-image3.png)
Part Number:
Description:
8-bit Atmel Microcontrollers
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
![ATMEGA1281V](/images/no-image3.png)
Part Number:
Description:
8-bit Atmel Microcontroller with 64K/128K/256K Bytes In-System Programmable Flash
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
![ATMEGA164A_11](/images/no-image3.png)
Part Number:
Description:
8-bit Atmel Microcontroller with 16/32/64/128K Bytes In-System Programmable Flash
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
![U641B](/images/manufacturer_photos/0/0/79/atmel_corporation_tmb.jpg)
Part Number:
Description:
INTERVAL AND WIPE/WASH WIPER CONTROL IC WITH DELAY
Manufacturer:
ATMEL Corporation
Datasheet:
![U4082B](/images/manufacturer_photos/0/0/79/atmel_corporation_tmb.jpg)
Part Number:
Description:
Low-Voltage Voice-Switched IC for Hands-Free Operation
Manufacturer:
ATMEL Corporation
Datasheet:
![U4089B](/images/manufacturer_photos/0/0/79/atmel_corporation_tmb.jpg)
Part Number:
Description:
MONOLITHIC INTEGRATED FEATUREPHONE CIRCUIT
Manufacturer:
ATMEL Corporation
Datasheet:
![U4255BM-M](/images/manufacturer_photos/0/0/79/atmel_corporation_tmb.jpg)
Part Number:
Description:
AM-FM Receiver IC U4255BM-M
Manufacturer:
ATMEL Corporation
Datasheet:
![U4089B-P](/images/manufacturer_photos/0/0/79/atmel_corporation_tmb.jpg)
Part Number:
Description:
Monolithic Integrated Feature Phone Circuit
Manufacturer:
ATMEL Corporation
Datasheet:
![TDA4470](/images/manufacturer_photos/0/0/79/atmel_corporation_tmb.jpg)
Part Number:
Description:
Multistandard Video-IF and Quasi Parallel Sound Processing
Manufacturer:
ATMEL Corporation
Datasheet: