ADUC847BCP8-5 AD [Analog Devices], ADUC847BCP8-5 Datasheet - Page 40

• Manufacturer Part Number: ADUC847BCP8-5
• Description: MicroConverter Multichannel 24-/16-Bit ADCs with Embedded 62 kB Flash and Single-Cycle MCU
• Manufacturer: AD [Analog Devices]

ADuC845/ADuC847/ADuC848
ADCSTAT (ADC STATUS REGISTER)
This SFR reflects the status of both ADCs including data ready, calibration, and various (ADC-related) error and warning conditions
including REFIN± reference detect and conversion overflow/underflow flags.
SFR Address:
Power-On Default:
Bit Addressable:
Table 23. ADCSTAT SFR Bit Designation
Bit No.
7
6
5
4
3
2
1
0
Name
RDY0
RDY1
CAL
NOXREF
ERR0
ERR1
–––
–––
D8H
00H
Yes
Description
Ready Bit for the Primary ADC.
Set by hardware on completion of conversion or calibration.
Cleared directly by the user or indirectly by a write to the mode bits to start calibration. The primary ADC is
inhibited from writing further results to its data or calibration registers until the RDY0 bit is cleared.
Ready Bit for Auxiliary (ADuC845 only) ADC.
Same definition as RDY0 referred to the auxiliary ADC. Valid on the ADuC845 only.
Calibration Status Bit.
Set by hardware on completion of calibration.
Cleared indirectly by a write to the mode bits to start another ADC conversion or calibration.
Note that calibration with the temperature sensor selected (auxiliary ADC on the ADuC845 only) fails to complete.
No External Reference Bit (only active if primary or auxiliary (ADuC845 only) ADC is active).
Set to indicate that one or both of the REFIN pins is floating or the applied voltage is below a specified threshold.
When set, conversion results are clamped to all 1s. Only detects invalid REFIN±, does not check REFIN2±.
Cleared to indicate valid V
Primary ADC Error Bit.
Set by hardware to indicate that the result written to the primary ADC data registers has been clamped to all 0s or
all 1s. After a calibration, this bit also flags error conditions that caused the calibration registers not to be written.
Cleared by a write to the mode bits to initiate a conversion or calibration.
Auxiliary ADC Error Bit. Same definition as ERR0 referred to the auxiliary ADC. Valid on the ADuC845 only.
Not Implemented. Write Don’t Care.
Not Implemented. Write Don’t Care.
REF
.
Rev. A | Page 40 of 108