sc16c751b NXP Semiconductors, sc16c751b Datasheet - Page 5

• Manufacturer Part Number: sc16c751b
• Description: 5 V, 3.3 V And 2.5 V Uart With 64-byte Fifos
• Manufacturer: NXP Semiconductors

NXP Semiconductors
6. Functional description
SC16C751B_2
Product data sheet
6.1 Internal registers
Table 2.
[1]
[2]
The SC16C751B provides serial asynchronous receive data synchronization,
parallel-to-serial and serial-to-parallel data conversions for both the transmitter and
receiver sections. These functions are necessary for converting the serial data stream into
parallel data that is required with digital data systems. Synchronization for the serial data
stream is accomplished by adding start and stop bits to the transmit data to form a data
character (character orientated protocol). Data integrity is insured by attaching a parity bit
to the data character. The parity bit is checked by the receiver for any transmission bit
errors. The SC16C751B is fabricated with an advanced CMOS process to achieve low
drain power and high speed requirements.
The SC16C751B is an upward solution that provides 64 bytes of transmit and receive
FIFO memory, instead of none in the 16C450, or 16 bytes in the 16C550. The
SC16C751B is designed to work with high speed modems and shared network
environments that require fast data processing time. Increased performance is realized in
the SC16C751B by the larger transmit and receive FIFOs. This allows the external
processor to handle more networking tasks within a given time. In addition, the four
selectable levels of FIFO trigger interrupt and automatic hardware flow control is uniquely
provided for maximum data throughput performance, especially when operating in a
multi-channel environment. The combination of the above greatly reduces the bandwidth
requirement of the external controlling CPU, increases performance, and reduces power
consumption.
The SC16C751B is capable of operation up to 5 Mbit/s with an 80 MHz external clock
input (at 5 V).
The rich feature set of the SC16C751B is available through internal registers. Automatic
hardware flow control, selectable transmit and receive FIFO trigger level, selectable TX
and RX baud rates, modem interface controls, and a Sleep mode are some of these
features.
The SC16C751B provides 12 internal registers for monitoring and control. These registers
are shown in
standard 16C550. These registers function as data holding registers (THR/RHR), interrupt
Symbol
IOW
XTAL1
XTAL2
HVQFN24 package die supply ground is connected to both V
be connected to supply ground for proper device operation. For enhanced thermal, electrical, and board
level performance, the exposed pad needs to be soldered to the board using a corresponding thermal pad
on the board and for proper heat conduction through the board, thermal vias need to be incorporated in the
PCB in the thermal pad region.
In Sleep mode, XTAL2 is left floating.
[2]
Pin description
Pin
9
7
8
Table
3. These twelve registers are similar to those already available in the
Type
I
I
O
Rev. 02 — 10 October 2008
…continued
Description
Write input. When IOW is active (LOW) and while the UART is
selected, the CPU is allowed to write control words or data into a
selected UART register.
Crystal connection or External clock input.
Crystal connection or the inversion of XTAL1 if XTAL1 is
driven.
5 V, 3.3 V and 2.5 V UART with 64-byte FIFOs
SS
pin and exposed center pad. V
SC16C751B
© NXP B.V. 2008. All rights reserved.
SS
pin must
5 of 32